M02011 Datasheet, PDF(16/22 Page) M/A-COM Technology Solutions, Inc. – CMOS Transimpedance Amplifier with AGC for Fiber Optic Networks up to 622 Mbps

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

M02011 Datasheet, PDF (16/22 Pages) M/A-COM Technology Solutions, Inc. – CMOS Transimpedance Amplifier with AGC for Fiber Optic Networks up to 622 Mbps

◁

M02011

CMOS Transimpedance Amplifier with AGC

for Fiber Optic Networks up to 622 Mbps

Rev V5

Figure 4-3. Typical Layout Diagram with Photodiode Mounted on TOCAN base (5 pin TOCAN)

DOUT

1nF

DOUTB

VCC

470pF MON

NOTE:

Typical application inside of a five lead TO-Can.

Only one of the VCC pads and all of the GND pads need to be connected. The backside must be connected to the lowest potential, usually ground, with conductive

epoxy or a similar die attach material. If a monitor output is not required then a four lead TO-Can may be used.

4.5

Treatment of PINK

PINK requires bypassing to ground with a capacitor when powering a photo diode. If PINK is not used to bias the

photo diode, then it is not necessary to bypass an unused PINK.

M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.

Visit www.macom.com for additional data sheets and product information.

For further information and support please visit:

http://www.macom.com/support

▷