WB40NBT Datasheet, PDF (24/26 Pages) Laird Tech Smart Technology – This document describes key hardware aspects of the Laird SDC-WB40NBT wireless bridge module

WB40NBT
Datasheet
9.2.3.2 User’s Guide Requirements
The integrator must include specific information in the user’s guide for the device into which the SDC-WB40NBT
is integrated. In addition to the required FCC and IC statements outlined above, the following R&TTE statements
must be added in their entirety and without modification into a prominent place in the user’s guide for the
device into which the SDC-WB40NBT is integrated:
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test
methods have been applied in order to prove presumption of conformity with the essential requirements of
the R&TTE Directive 1999/5/EC:
 EN60950-1:2001 A11:2004
Safety of Information Technology Equipment
 EN 300 328 V1.7.1: (2006-10)
Electromagnetic compatibility and Radio Spectrum Matters (ERM); Wideband Transmission systems;
Data transmission equipment operating in the 2,4 GHz ISM band and using spread spectrum modulation
techniques; Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive
 EN 301 489-1 V1.6.1: (2005-09)
Electromagnetic compatibility and Radio Spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC)
standard for radio equipment and services; Part 1: Common technical requirements
 EN 301 489-17 V1.2.1 (2002-08)
Electromagnetic compatibility and Radio Spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC)
standard for radio equipment and services; Part 17: Specific conditions for 2,4 GHz wideband
transmission systems and 5 GHz high performance RLAN equipment
 EN 301 893 V1.5.1 (2008-12)
Electromagnetic compatibility and Radio Spectrum Matters (ERM); Broadband Radio Access Networks
(BRAN); Specific conditions for 5 GHz high performance RLAN equipment
 EU 2002/95/EC (RoHS)
Declaration of Compliance – EU Directive 2003/95/EC; Reduction of Hazardous Substances (RoHS)
This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU member
states and EFTA countries, except in France and Italy where restrictive use applies.
In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain
authorization to use the device for setting up outdoor radio links and/or for supplying public access to
telecommunications and/or network services.
This device may not be used for setting up outdoor radio links in France and in some areas the RF output
power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed information
the end-user should contact the national spectrum authority in France.
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
24
© Copyright 2015 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]