LTC3410B_15 Datasheet, PDF (7/16 Pages) Linear Technology – 2.25MHz, 300mA Synchronous Step-Down Regulator in SC70

U
OPERATIO (Refer to Functional Diagram)
Main Control Loop
The LTC3410B uses a constant frequency, current mode
step-down architecture. Both the main (P-channel
MOSFET) and synchronous (N-channel MOSFET) switches
are internal. During normal operation, the internal top
power MOSFET is turned on each cycle when the oscillator
sets the RS latch, and turned off when the current com-
parator, I_COMP, resets the RS latch. The peak inductor
current at which I_COMP resets the RS latch, is controlled by
the output of error amplifier EA. The V_FB pin, described in
the Pin Functions section, allows EA to receive an output
feedback voltage from an external resistive divider. When
the load current increases, it causes a slight decrease in
the feedback voltage relative to the 0.8V reference, which
in turn, causes the EA amplifier’s output voltage to in-
crease until the average inductor current matches the new
load current. While the top MOSFET is off, the bottom
MOSFET is turned on until either the inductor current
starts to reverse, as indicated by the current reversal
comparator I_RCMP, or the beginning of the next clock cycle.
Pulse Skipping Mode Operation
At light loads, the inductor current may reach zero or re-
verse on each pulse. The bottom MOSFET is turned off by
the current reversal comparator, I_RCMP, and the switch
voltage will ring. This is discontinuous mode operation,
and is normal behavior for the switching regulator. At very
light loads, the LTC3410B will automatically skip pulses in
pulse skipping mode operation to maintain output regula-
tion. Refer to LTC3410 data sheet if Burst Mode^® operation
is preferred.
Short-Circuit Protection
When the output is shorted to ground, the frequency of the
oscillator is reduced to about 310kHz, 1/7 the nominal
LTC3410B
frequency. This frequency foldback ensures that the in-
ductor current has more time to decay, thereby preventing
runaway. The oscillator’s frequency will progressively
increase to 2.25MHz when V_FB rises above 0V.
Dropout Operation
As the input supply voltage decreases to a value approach-
ing the output voltage, the duty cycle increases toward the
maximum on-time. Further reduction of the supply volt-
age forces the main switch to remain on for more than one
cycle until it reaches 100% duty cycle. The output voltage
will then be determined by the input voltage minus the
voltage drop across the P-channel MOSFET and the
inductor.
Another important detail to remember is that at low input
supply voltages, the R_DS(ON) of the P-channel switch
increases (see Typical Performance Characteristics).
Therefore, the user should calculate the power dissipation
when the LTC3410B is used at 100% duty cycle with low
input voltage (See Thermal Considerations in the Applica-
tions Information section).
Slope Compensation and Inductor Peak Current
Slope compensation provides stability in constant fre-
quency architectures by preventing subharmonic oscilla-
tions at high duty cycles. It is accomplished internally by
adding a compensating ramp to the inductor current
signal at duty cycles in excess of 40%. Normally, this
results in a reduction of maximum inductor peak current
for duty cycles > 40%. However, the LTC3410B uses a
patented scheme that counteracts this compensating
ramp, which allows the maximum inductor peak current
to remain unaffected throughout all duty cycles.
Burst Mode is a Registered Trademark of Linear Technology Corporation.
3410bfa
7