W2308EP Datasheet, PDF (9/26 Pages) Keysight Technologies – Quick Start for Signal Integrity

A. Complete the Schematic
–– Pick and place the EyeDiff PROBE
(differential
eye probe) from the Simulation-ChannelSim palette
onto the schematic. The schematic should have three
connected components.
–– Double click on the Tx_Diff1 instance
dialog box.
to open its
On the PRBS tab set:
–– Set Bit Rate = 5 Gbps
–– Vhigh = 1.2V
–– Vlow = -1.2V
–– Rise/Fall Time = 30 ps
–– Register Length = 7
TIP:
Any time you make a mistake, you can simply click on the
undo button
on the toolbar. If you change your mind,
you can undo the undoing by clicking on the redo button
.
You can set up the parameters of a given component
instance directly on the schematic or via its dialog box. We
will use the latter method for now.
Click on the [Help] button at the bottom of the dialog
box to bring up the documentation page for the Tx_Diff
component.
The documentation pages contain a wealth of information
about the parameters and algorithms used.
9