JHB7036A Datasheet, PDF (36/36 Pages) Jewel Hill Electronic – SPECIFICATIONS FOR LCD MODULE

JEWEL HILL ELECTRONIC CO.,LTD.
No
Item
Criterion
AQL
13 Bezel
1Bezel may not have rust, be deformed or have fingerprints,
2.5
stains or other contamination.
2 Bezel must comply with job specifications.
0.65
14 Soldering
1 No unmated solder paste may be present on the PCB.
2.5
2 No cold solder joints, missing solder connections, oxidation
2.5
or icicle.
3 No short circuits in components on PCB.
0.65
1 No oxidation, contamination, curves or, bends on interface
2.5
Pin (OLB) of TCP.
2 No cracks on interface pin (OLB) of TCP.
0.65
3 No contamination, solder residue or solder balls on
2.5
product.
4 The IC on the TCP may not be damaged, circuits.
2.5
5 The uppermost edge of the protective strip on the interface
pin must be present or look as if it causes the interface pin 2.5
to sever.
General 6 The residual rosin or tin oil of soldering (component or
15
2.5
Appearance
chop component) is not burned into brown or black color.
7 Sealant on top of the ITO circuit has not hardened.
2.5
8 Pin type must match type in specification sheet.
2.5
9 LCD pin loose or missing pins.
0.65
10 Product packaging must the same as specified on
0.65
packaging specification sheet.
11 Product dimension and structure must conform to product
specification sheet.
0.65
12 The appearance of Heat Seal should not admit any dirt and
0.65
break.
JHB7036A VER: 01.01
- 35 -
Issue date: 2013-08-01