031-1007-054 Datasheet, PDF (44/62 Pages) ITT Industries – Ensuring over 20 years of mission critical communication between two worlds across 250,000,000 milies

Contact Cavities and Assembly Instructions
Face View Pin Insert
(Use a mirror image for
receptacle).
Shell Size
Contact Arrangement
Contact Size
Standard Density
Contact Arrangements
E
A
B
9
15
25
#20
#20
#20
C
D
37
50
#20
#20
Face View Pin Insert
(Use a mirror image for
receptacle).
Shell size
Contact Arrangement
Contact Size
High Density
C
Wire-Stripping – Machine Contacts
A
1
5
6
10
11
15
1
10
19
E
15
#22
1
22
43
C
62
#22
9
18
26
A
26
#22
21
42
62
1
21
40
60
1
16
31
D
78
#22
Assembly Instructions
Contact Crimping
Contact Insertion
B
44
#22
20
39
59
78
15
30
44
A
Min.
Max.
.188 (4.78)
.208 (5.28)
1. Cut wires to length. Strip insulation per above illustration. 2. Insert contact and wire into proper crimp tool (and locator, if
Check for frayed or broken wires.
required). Crimp contact to wire. Inspect crimp.
Contact Extraction
3. Center wired contact into groove of insertion tool with
tool tip butting contact shoulder. Insert contact into cav-
ity until a positive stop is felt. Inspect insertion.
4. To be sure contact is locked securely, pull back lightly on wire.
Repeat for balance of contacts working row by row across
the insulator.
5. Place wire into extraction tool tip.
C-44
6. Insert tool tip into contact cavity until tip bottoms against
contact shoulder, releasing tines. Hold wire against tool
with finger and remove tool and contact. Repeat for bal-
ance of contacts.
Dimensions shown in inches (mm)
Specifications and dimensions subject to change
www.ittcannon.com