031-1007-054 Datasheet, PDF (39/62 Pages) ITT Industries – Ensuring over 20 years of mission critical communication between two worlds across 250,000,000 milies

Grommet D
GD*
Test Data
GD* connectors meet all applicable requirements of MIL-C-24308. The following are exerpts from ITT Cannon Test Can-
non Test Report C82-78 applicable to environmental D-Subminiature GD* series connectors. Refer to MIL-C- 24308 Test
Extracts on page 385.
Test
Description
Moisture Resistant
Fluid Immersion
Immersion
Test
Method
Results
MIL-STD-1344
Method 1002.1 Type II
1. No deterioration of performance.
2. Insulation resistance greater than 100 megaohms.
3. No evidence of flashover or breakdown during 1000 VAC
DWV testing.
20 hours immersion in hydraulic
fluid per MIL-L-23699.
1. No detrimental damage.
2. Able to meet requirements of mating and
unmating test.
Two hours immersion in tap water While still immersed, the mated connectors exceeded
at a depth of 36.00 (914.40) in 100 megaohm insulator resistance and exhibited no
mated condition, per MIL-STD 810, evidence of breakdown or flashover during 1000 VAC
Method 512, Procedure 1.
(RMS) DWV testing.
Design Features
• Resilient silicone grommets for wire sealing
• Interfacial seals
• Closed-entry socket contacts
• Bonded components to prevent moisture
• Uses M39029 type contacts and termination tool-
ing
• Intermateable with most M24308 type connectors
• Rear-release crimp contacts
• LITTLE CAESAR^® contact retention assembly
• Optional sealing plugs, ITT Cannon part number
CLOSED ENTRY
SOCKET
BONDING
SEALING PLUG
(OPTIONAL)
C
SHELL
FRONT
INSULATOR
CONTACT
RETAINING
CLIP
SHELL
REAR
Socket Connector
GROMMET
INSULATOR
PIN
CONTACT
BONDING
SEALING PLUG
(OPTIONAL)
Note: Crimp Contacts: See page C-13
SHELL
FRONT
INTERFACIAL CONTACT
SEAL
RETAINING
CLIP
SHELL
REAR
Pin Connector
GROMMET
Dimensions shown in inches (mm)
Specifications and dimensions subject to change
www.ittcannon.com
C-39