X9314_06 Datasheet, PDF (8/9 Pages) Intersil Corporation – Single Digitally Controlled Potentiometer

X9314
Small Outline Plastic Packages (SOIC)
N
INDEX
AREA
H
E
-B-
0.25(0.010) M B M
123
-A-
D
SEATING PLANE
A
L
h x 45°
-C-
α
e
A1
C
B
0.10(0.004)
0.25(0.010) M C A M B S
NOTES:
1. Symbols are defined in the “MO Series Symbol List” in Section 2.2 of
Publication Number 95.
2. Dimensioning and tolerancing per ANSI Y14.5M-1982.
3. Dimension “D” does not include mold flash, protrusions or gate burrs.
Mold flash, protrusion and gate burrs shall not exceed 0.15mm (0.006
inch) per side.
4. Dimension “E” does not include interlead flash or protrusions. Inter-
lead flash and protrusions shall not exceed 0.25mm (0.010 inch) per
side.
5. The chamfer on the body is optional. If it is not present, a visual index
feature must be located within the crosshatched area.
6. “L” is the length of terminal for soldering to a substrate.
7. “N” is the number of terminal positions.
8. Terminal numbers are shown for reference only.
9. The lead width “B”, as measured 0.36mm (0.014 inch) or greater
above the seating plane, shall not exceed a maximum value of
0.61mm (0.024 inch).
10. Controlling dimension: MILLIMETER. Converted inch dimensions
are not necessarily exact.
M8.15 (JEDEC MS-012-AA ISSUE C)
8 LEAD NARROW BODY SMALL OUTLINE PLASTIC PACKAGE
INCHES
MILLIMETERS
SYMBOL MIN
MAX
MIN
MAX NOTES
A
0.0532 0.0688 1.35
1.75
-
A1
0.0040 0.0098 0.10
0.25
-
B
0.013 0.020 0.33
0.51
9
C
0.0075 0.0098 0.19
0.25
-
D
0.1890 0.1968 4.80
5.00
3
E
0.1497 0.1574 3.80
4.00
4
e
0.050 BSC
1.27 BSC
-
H
0.2284 0.2440 5.80
6.20
-
h
0.0099 0.0196 0.25
0.50
5
L
0.016 0.050 0.40
1.27
6
N
8
8
7
α
0°
8°
0°
8°
-
Rev. 1 6/05
8
FN8178.2
September 5, 2006