English
Language : 

X9314_06 Datasheet, PDF (1/9 Pages) Intersil Corporation – Single Digitally Controlled Potentiometer
®
Data Sheet
X9314
Terminal Voltages ±5V, 32 Taps, Log Taper
September 5, 2006
FN8178.2
Single Digitally Controlled Potentiometer
(XDCP™)
The Intersil X9314 is a solid state nonvolatile potentiometer and
is ideal for digitally controlled resistance trimming.
The X9314 is a resistor array composed of 31 resistive
elements. Between each element and at either end are tap
points accessible to the wiper element. The position of the
wiper element is controlled by the CS, U/D, and INC inputs.
The position of the wiper can be stored in nonvolatile
memory and then be recalled upon a subsequent power-up
operation.
The XDCP can be used as a three-terminal potentiometer or
as a two-terminal variable resistor in a wide variety of
applications including control, parameter adjustments, and
signal processing.
Block Diagram
Features
• Solid State Potentiometer
• 32 Taps
• 10kΩ End to End Resistance
• Three-Wire Up/Down Serial Interface
• Wiper Resistance, 40Ω Typical
• Nonvolatile Storage and Recall on Power-up of Wiper
Position Standby Current < 500µA Max (Total Package)
• VCC = 3V to 5.5V Operation
• 100 Year Data Retention
• Offered in 8 Ld MSOP, SOIC and PDIP Packages
• Pb-Free Plus Anneal Available (RoHS Compliant)
U/D
5-Bit
INC
Up/Down
CS
Counter
5-Bit
Nonvolatile
Memory
VCC
VSS
Store and
Recall
Control
Circuitry
31
30
29
28
One
of
Thirty-Two
Decoder
2
1
0
Transfer
Gates
VH/RH
Resistor
Array
VL/RL
VW/RW
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
XDCP is a trademark of Intersil Americas Inc. Copyright Intersil Americas Inc. 2005, 2006. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.