|
ISL78419_15 Datasheet, PDF (8/20 Pages) Intersil Corporation – Integrated Automotive TFT-LCD Power Supply Regulator | |||
|
◁ |
ISL78419
Serial Interface Specifications For SCL and SDA Unless Otherwise Noted. (Continued)
SYMBOL
PARAMETER
TEST CONDITIONS
MIN
(Note 14)
TYP
MAX
(Note 7) (Note 14) UNITS
tHD:STO STOP Condition Hold Time for Read, or From SDA rising edge to SCL falling edge;
400
ns
Volatile Only Write
both crossing 70% of VIN
CSCL Capacitive on SCL
5
pF
CSDA Capacitive on SDA
5
pF
tWp Non-Volatile Write Cycle Time
25
ms
EEPROM Endurance
TA = +25°C
1
kCyc
EEPROM Retention
TA = +25°C
88
kHrs
NOTES:
6. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization
and are not production tested.
7. Typical values are for TA = +25°C and VIN = 3.3V.
8. LSB = I V255 - V1I/254. V255 and V1 are the measured voltages for the DCP register set to FF hex and 01 hex respectively.
9. DNL = I Vi+1 - Vi I/LSB-1, i ï ï1ï¬ 255ï
10. ZS error = (V1 -VMIN)/LSB. VMIN = (VAVDD*R2) * [1-254*R1/(255*20*RSET)]/ (R1+R2).
11. FS error = (V255 - VMAX)/LSB. VMAX = (VAVDD*R2) * [1-0*R1/(255*20*RSET)]/ (R1+R2).
12. Established by design. Not a parametric specification.
13. Boost will stop switching as soon as boost output reaches OVP threshold.
14. Compliance to limits is assured by characterization and design.
Submit Document Feedback
8
FN8292.3
June 27, 2014
|
▷ |