X5163S8IZT1 Datasheet, PDF (7/22 Pages) Intersil Corporation – Selectable watchdog timer

X5163, X5165
SPI Serial Memory
The memory portion of the device is a CMOS Serial EEPROM
array with Intersil’s block lock protection. The array is
internally organized as x 8. The device features a Serial
Peripheral Interface (SPI) and software protocol allowing
operation on a simple four-wire bus.
The device utilizes Intersil’s proprietary Direct Write^™ cell,
providing a minimum endurance of 100,000 cycles and a
minimum data retention of 100 years.
The device is designed to interface directly with the
synchronous Serial Peripheral Interface (SPI) of many
popular microcontroller families. It contains an 8-bit
instruction register that is accessed via the SI input, with
data being clocked in on the rising edge of SCK. CS must be
LOW during the entire operation.
All instructions (Table 1), addresses and data are transferred
MSB first. Data input on the SI line is latched on the first
rising edge of SCK after CS goes LOW. Data is output on the
SO line by the falling edge of SCK. SCK is static, allowing
the user to stop the clock and then start it again to resume
operations where left off.
Write Enable Latch
The device contains a Write Enable Latch. This latch must
be SET before a Write Operation is initiated. The WREN
instruction will set the latch and the WRDI instruction will
reset the latch (Figure 7). This latch is automatically reset
upon a power-up condition and after the completion of a
valid Write Cycle.
Status Register
The RDSR instruction provides access to the Status
Register. The Status Register may be read at any time, even
during a Write Cycle. The Status Register is formatted as
follows:
7
WPEN
6
5
4
3
2
1
0
FLB WD1 WD0 BL1 BL0 WEL WIP
The Write-In-Progress (WIP) bit is a volatile, read only bit
and indicates whether the device is busy with an internal
nonvolatile write operation. The WIP bit is read using the
RDSR instruction. When set to a “1”, a nonvolatile write
operation is in progress. When set to a “0”, no write is in
progress.
TABLE 1. INSTRUCTION SET
INSTRUCTION NAME INSTRUCTION FORMAT*
OPERATION
WREN
0000 0110
Set the Write Enable Latch (Enable Write Operations)
SFLB
0000 0000
Set Flag Bit
WRDI/RFLB
0000 0100
Reset the Write Enable Latch/Reset Flag Bit
RDSR
0000 0101
Read Status Register
WRSR
0000 0001
Write Status Register (Watchdog,BlockLock,WPEN & Flag Bits)
READ
0000 0011
Read Data from Memory Array Beginning at Selected Address
WRITE
0000 0010
Write Data to Memory Array Beginning at Selected Address
NOTE: *Instructions are shown MSB in leftmost position. Instructions are transferred MSB first.
WREN CMD
WEL
0
1
1
1
STATUS REGISTER
TABLE 2. BLOCK PROTECT MATRIX
DEVICE PIN
BLOCK
BLOCK
WPEN
X
1
0
X
WP#
X
0
X
1
PROTECTED BLOCK UNPROTECTED BLOCK
Protected
Protected
Protected
Writable
Protected
Writable
Protected
Writable
STATUS REGISTER
WPEN, BL0, BL1, WD0,
WD1
Protected
Protected
Writable
Writable
Submit Document Feedback
7
FN8128.4
August 13, 2015