ISL6753 Datasheet, PDF (7/15 Pages) Intersil Corporation – ZVS Full-Bridge PWM Controller

Typical Performance Curves
ISL6753
1.02
1.01
1
0.99
0.98
40 25 10 5 20 35 50 65 80 95 110
Temperature (C)
FIGURE 1. REFERENCE VOLTAGE vs TEMPERATURE
1 ^.10⁴
1 ^.10³
CT =
1000pF
680pF
470pF
330pF
220pF
100pF
100
10
0 10 20 30 40 50 60 70 80 90 100
RTD (kohms)
FIGURE 3. DEADTIME (DT) vs CAPACITANCE
Pin Descriptions
VDD - VDD is the power connection for the IC. To optimize
noise immunity, bypass VDD to GND with a ceramic
capacitor as close to the VDD and GND pins as possible.
Supply voltage under-voltage lock-out (UVLO) start and stop
thresholds track each other resulting in relatively constant
hysteresis.
GND - Signal and power ground connections for this device.
Due to high peak currents and high frequency operation, a
low impedance layout is necessary. Ground planes and
short traces are highly recommended.
VREF - The 5.00V reference voltage output having 3%
tolerance over line, load and operating temperature. Bypass
to GND with a 0.1µF to 2.2µF low ESR capacitor.
CT - The oscillator timing capacitor is connected between
this pin and GND. It is charged through an internal 200µA
current source and discharged with a user adjustable current
source controlled by RTD.
7
25
24
23
22
21
20
19
18
0 200 400 600 800 1000
RTD Current (uA)
FIGURE 2. CT DISCHARGE CURRENT GAIN vs RTD CURRENT
1 ^.10³
100
10
0.1
1
CT (nF)
RTD=
10kΩ
50kΩ
100kΩ
10
FIGURE 4. CAPACITANCE vs FREQUENCY
RTD - This is the oscillator timing capacitor discharge
current control pin. The current flowing in a resistor
connected between this pin and GND determines the
magnitude of the current that discharges CT. The CT
discharge current is nominally 20x the resistor current. The
PWM deadtime is determined by the timing capacitor
discharge duration. The voltage at RTD is nominally 2.00V.
CS - This is the input to the overcurrent comparator. The
overcurrent comparator threshold is set at 1.00V nominal.
The CS pin is shorted to GND at the termination of either
PWM output.
Depending on the current sensing source impedance, a
series input resistor may be required due to the delay
between the internal clock and the external power switch.
This delay may result in CS being discharged prior to the
power switching device being turned off.
RAMP - This is the input for the sawtooth waveform for the
PWM comparator. The RAMP pin is shorted to GND at the
termination of the PWM signal. A sawtooth voltage
FN9182.1
March 10, 2005