DG406_14 Datasheet, PDF (7/15 Pages) Intersil Corporation – Single 16-Channel/Differential 8-Channel, CMOS Analog Multiplexers

DG406, DG407
Electrical SpecificationsMSingle Supply Test Conditions: V+ = 12V, V- = 0V, V_AL = 0.8V, V_AH = 2.4V,
Unless Otherwise Specified. (Continued)
PARAMETER
TEST
CONDITIONS
TEMP
(°C)
MIN
(Notes 7, 12)
TYP
(Note 8)
MAX
(Notes 7, 12)
UNITS
Drain On Leakage Current, I_D(ON)
V_S = V_D = ±10V (Note 9)
DG406
25
-
0.04
-
nA
DG407
25
-
0.04
-
nA
POWER SUPPLY CHARACTERISTICS
Positive Supply Current (I+)
(Standby)
V_EN = 0V or 5V, V_A = 0V or 5V
25
-
Full
-
13
30
µA
13
75
µA
Negative Supply Current (I-)
(Enabled)
25
-1
-0.01
-
µA
Full
-5
-0.01
-
µA
NOTES:
7. The algebraic convention whereby the most negative value is a minimum and the most positive a maximum, is used in this data sheet.
8. Typical values are for design only and are not production tested.
9. Sequence each switch ON.
10. Δr_DS(ON) = (r_DS(ON)(Max) - r_DS(ON)(Min)) ÷ r_DS(ON) average.
11. Worst case isolation occurs on channel 8B due to proximity to the drain pin.
12. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization
and are not production tested.
Test Circuits and Waveforms
+15V
+2.4V
LOGIC
INPUT
50Ω
EN ^V+
S₁
A3
S₂ - S₁₅
A₂
A₁
DG406 _S16
A_{0 GND V-} D
±10V
10V
300Ω
-15V
V_O
35pF
FIGURE 3A. DG406 TEST CIRCUIT
+15V
+2.4V
LOGIC
INPUT
50Ω
EN ^V+ S_1B
±10V
†
A₂
DG407
A₁
S_8B
10V
A_{0 GND V-} D_B
300Ω
-15V
† = S_1A - S_8A, S_2B - S_7B, D_A
FIGURE 3B. DG407 TEST CIRCUIT
V_O
35pF
LOGIC ^3V
INPUT _0V
V_S1B
SWITCH
OUTPUT _0V
V_O
V_S8B
S₁ ON
t_TRANS
50%
50%
80% V_S8
S₈ ON
FIGURE 3C. MEASUREMENT POINTS
FIGURE 3. TRANSITION TIME
t_r < 20ns
t_f < 20ns
80% VS1
t_TRANS
7
FN3116.11
October 1, 2013