English
Language : 

DG406_14 Datasheet, PDF (5/15 Pages) Intersil Corporation – Single 16-Channel/Differential 8-Channel, CMOS Analog Multiplexers
◁
DG406, DG407
Absolute Maximum Ratings
V+ to V-. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44.0V
GND to V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25V
Digital Inputs, VS, VD (Note 6)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(V-) -2V to (V+) +2V or 20mA,
Whichever Occurs First
Continuous Current (Any Terminal) . . . . . . . . . . . . . . . . . . . . . . . . . 30mA
Peak Current, S or D
(Pulsed 1ms, 10% Duty Cycle Max) . . . . . . . . . . . . . . . . . . . . . . . . . 100mA
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40°C to +85°C
Thermal Information
Thermal Resistance (Typical, Note 5)
θJA (°C/W)
PDIP Package*. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
60
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
75
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . .+150°C
Maximum Storage Temperature Range . . . . . . . . . . . . . .-65°C to +150°C
Pb-Free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
*Pb-free PDIPs can be used for through-hole wave solder processing only.
They are not intended for use in Reflow solder processing applications.
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product
reliability and result in failures not covered by warranty.
NOTES:
5. θJA is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
6. Signals on SX, DX, EN or AX exceeding V+ or V- are clamped by internal diodes. Limit diode current to maximum current ratings.
Electrical Specifications Test Conditions: V+ = +15V, V- = -15V, VAL = 0.8V, VAH = 2.4V Unless Otherwise Specified. Bold-face limits
apply over the operating temperature range, -40°C to +85°C.
PARAMETER
DYNAMIC CHARACTERISTICS
Transition Time, tTRANS
TEST CONDITIONS
(See Figure 3)
Break-Before-Make Interval, tOPEN
(See Figure 5)
Enable Turn-ON Time, tON(EN)
(See Figure 4)
Enable Turn-OFF Time, tOFF(EN)
Charge Injection, Q
OFF-Isolation, OIRR
Logic Input Capacitance, CIN
Source OFF Capacitance, CS(OFF)
Drain OFF Capacitance, CD(OFF)
DG406
DG407
Drain ON Capacitance, CD(ON)
DG406
DG407
DIGITAL INPUT CHARACTERISTICS
Logic High Input Voltage, VINH
Logic Low Input Voltage, VINL
Logic High Input Current, IAH
Logic Low Input Current, IAL
ANALOG SWITCH CHARACTERISTICS
Drain-Source ON-Resistance, rDS(ON)
CL = 1nF, VS = 0V, RS = 0Ω
VEN = 0V, RL = 1kΩ,
f = 100kHz (Note 11)
f = 1MHz
VEN = 0V, VS = 0V, f = 1MHz
VEN = 0V, VD = 0V, f = 1MHz
VEN = 5V, VD = 0V, f = 1MHz
VA = 2.4V, 15V
VEN = 0V, 2.4V, VA = 0V
VD = ±10V, IS = +10mA
(Note 9)
rDS(ON) Matching Between Channels, ΔrDS(ON) VD = 10V, -10V (Note 10)
TEMP
(°C)
25
Full
25
Full
25
Full
25
Full
25
25
25
25
25
25
25
25
Full
Full
Full
Full
25
Full
25
MIN
(Notes 7, 12)
-
-
25
10
-
-
-
-
-
-
-
-
-
-
-
-
2.4
-
-1
-1
-
-
-
TYP
(Note 8)
200
-
50
-
150
-
70
-
40
-69
7
8
160
80
180
90
-
-
-
-
50
-
5
MAX
(Notes 7, 12)
300
400
-
-
200
400
150
300
-
-
-
-
-
-
-
-
-
0.8
1
1
100
125
-
UNITS
ns
ns
ns
ns
ns
ns
ns
ns
pC
dB
pF
pF
pF
pF
pF
pF
V
V
µA
µA
Ω
Ω
%
5
FN3116.11
October 1, 2013
 ▷