ISL32172E Datasheet, PDF (6/20 Pages) Intersil Corporation – QUAD, ±16.5kV ESD Protected, 3.0V to 5.5V, Low Power, RS-422 Transmitters

ISL32172E, ISL32272E, ISL32372E, ISL32174E, ISL32274E, ISL32374E, ISL32179E
Absolute Maximum Ratings
V_CC to GND. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7V
V_L to GND (ISL32179E Only) . . . . . . . . . . . . . -0.3V to (V_CC +0.3V)
Input Voltages
DI, EN (all varieties) . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 7V
Output Voltages
Y, Z . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to 7V
Output Current
Y, Z (Per Output, Continuous, T_J ≤ 125°C) . . . . . . . . . . . . 100mA
ESD Rating . . . . . . . . . . . . . . . . . . . . . . . . . See Specification Table
Thermal Information
Thermal Resistance (Typical)
θ_JA (°C/W) θ_JC (°C/W)
16 Ld SOIC Package (Note 3) . . . . . . .
80
N/A
16 Ld TSSOP Package (Note 3) . . . . . 105
N/A
24 Ld QFN Package (Notes 4, 5). . . . .
42
5
Maximum Junction Temperature (Plastic Package) . . +150°C
Maximum Storage Temperature Range . . . . . . . . . .-65°C to +150°C
Pb-free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
Operating Conditions
Temperature Range
ISL32x7xEF . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-40°C to +125°C
ISL32x7xEI. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-40°C to +85°C
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTE:
3. θ_JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
4. θ_JA is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See
Tech Brief TB379 for details.
5. For θ_JC, the “case temp” location is the center of the exposed metal pad on the package underside.
Electrical Specifications
PARAMETER
DC CHARACTERISTICS
Differential V_OUT
Single-Ended V_OUT (Y or Z)
Change in Magnitude of Driver
Differential V_OUT for
Complementary Output States
Driver Common-Mode V_OUT
Change in Magnitude of Driver
Common-Mode V_OUT for
Complementary Output States
Input High Voltage (Logic Pins,
Note 14)
Input Low Voltage (Logic Pins,
Note 14)
Test Conditions: V_CC = 3.0V to 3.6V and 4.5V to 5.5V; V_L = V_CC (ISL32179E only); Typicals are at V_CC = 3.3V
or V_CC = 5V, T_A = +25°C; Unless Otherwise Specified.(Notes 6, 10)
SYMBOL
TEST CONDITIONS
TEMP MIN
MAX
(°C) (Note 9) TYP (Note 9) UNITS
V_OD
V_O
ΔV_OD
No Load
R_L = 100Ω (RS-422)
(see Figure 1)
V_CC ≥ 3V
V_CC ≥ 4.5V
I_O = -20mA, V_OH
I_O = 20mA, V_OL
R_L = 100Ω (see Figure 1)
Full
2.5
-
V_CC
Full
2
2.6
-
V
Full
3
4
-
V
Full
2.4
2.7
-
V
Full
-
0.2
0.4
V
Full
-
0.01
0.2
V
V_OC
ΔV_OC
R_L = 100Ω (see Figure 1)
R_L = 100Ω (see Figure 1)
Full
-
2.6
3
V
Full
-
0.01
0.2
V
V_IH1
V_IH2
V_IH2E
V_IH3
V_IH4
V_IH5
V_IH6
V_IL1
V_IL2
V_IL3
V_IL4
V_IL5
V_L = V_CC if ISL32179E V_CC ≤ 3.6V
V_CC ≤ 5.5V, DI
V_CC ≤ 5.5V, ENs
2.7V ≤ V_L < 3.0V (ISL32179E Only)
2.3V ≤ V_L < 2.7V (ISL32179E Only)
1.6V ≤ V_L < 2.3V (ISL32179E Only)
1.5V ≤ V_L < 1.6V (ISL32179E Only)
V_L = V_CC if ISL32179E
V_L ≥ 2.7V (ISL32179E Only)
2.3V ≤ V_L < 2.7V (ISL32179E Only)
1.6V ≤ V_L < 2.3V (ISL32179E Only)
1.5V ≤ V_L < 1.6V (ISL32179E Only)
Full
2.2
-
-
V
Full
2.7
-
-
V
Full
2.4
-
-
V
Full
2
-
-
V
Full
1.6
-
-
V
Full 0.72*V_L
-
-
V
25
-
0.45*V_L
-
V
Full
-
-
0.8
V
Full
-
-
0.6
V
Full
-
-
0.6
V
Full
-
-
0.22*V_L V
25
-
0.25*V_L
-
V
6
FN6824.0
December 16, 2008