X60003 Datasheet, PDF (5/16 Pages) Intersil Corporation – Calibration systems

X60003
Electrical Specifications (X60003-50) V_IN = 6.5V, T_A = -40°C to +85°C, unless otherwise specified. Boldface limits apply over
the operating temperature range, -40°C to +85°C.
SYMBOL
PARAMETER
CONDITIONS
MIN
MAX
(Note 12) TYP (Note 12) UNITS
V_IN
Input Voltage Range
5.1
9.0
V
V_OUT
Output Voltage
5.000
V
V_OUT/V_IN Line Regulation
+5.5V  V_IN  +8.0V
150
µV/V
V_OUT/I_OUT Load Regulation
Sourcing: 0mA I_SOURCE  10mA
10
50
µV/mA
Sinking: -10mA  I_SINK  0mA
20
100
µV/mA
V_DO
Dropout Voltage
I_OUT = 5mA, V_OUT = -0.01%
150
300
mV
V_OUT/T_A Thermal Hysteresis (Note 10)
T = -40°C to +85°C
100
ppm
V_OUT/t
Long Term Stability (Note 11)
T_A = +25°C
45
ppm
NOTES:
9. Over the specified temperature range. Temperature coefficient is measured by the box method whereby the change in V_OUT is divided by the
temperature range; in this case, -40°C to +85°C = +125°C.
10. Thermal Hysteresis is the change of V_OUT measured at T_A = +25°C after temperature cycling over a specified range, T_A. V_OUT is read initially at
T_A = +25°C for the device under test. The device is temperature cycled and a second V_OUT measurement is taken at +25°C. The difference between
the initial V_OUT reading and the second V_OUT reading is then expressed in ppm. For  T_A = +125°C, the device under test is cycled from +25°C to
+85°C to -40°C to +85°C.
11. Long term drift is logarithmic in nature and diminishes over time. Drift after the first 1000 hours will be approximately 10ppm/sqrt(1kHrs).
12. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization
and are not production tested.
Submit Document Feedback
5
FN8137.5
September 1, 2015