X4163-65 Datasheet, PDF (5/22 Pages) Intersil Corporation – Selectable watchdog timer

X4163, X4165
PRINCIPLES OF OPERATION
Power On Reset
Application of power to the X4163, X4165 activates a
Power On Reset Circuit that pulls the RESET/RESET
pin active. This signal provides several benefits.
It prevents the system microprocessor from starting to
operate with insufficient voltage.
It prevents the processor from operating prior to stabilization
of the oscillator.
It allows time for an FPGA to download its configuration prior
to initialization of the circuit.
It prevents communication to the EEPROM, greatly reducing
the likelihood of data corruption on power up.
When V_CC exceeds the device V_TRIP threshold value for
200ms (nominal) the circuit releases RESET/RESET allowing
the system to begin operation.
LOW VOLTAGE MONITORING
During operation, the X4163, X4165 monitors the V_CC level
and asserts RESET/RESET if supply voltage falls below a
preset minimum V_TRIP. The RESET/RESET signal prevents
the microprocessor from operating in a power fail or
brownout condition. The RESET/RESET signal remains
active until the voltage drops below 1V. It also remains active
until V_CC returns and exceeds V_TRIP for 200ms.
WATCHDOG TIMER
The Watchdog Timer circuit monitors the microprocessor
activity by monitoring the SDA and SCL pins. The
microprocessor must periodically send a start bit followed by
a stop bit prior to the expiration of the watchdog time out
period to prevent a RESET/RESET signal. The start and
stop bits need to be separated by SCL toggling low then high
at least one time.
The state of two nonvolatile control bits in the Status
Register determine the watchdog timer period. The
microprocessor can change these watchdog bits, or they
may be “locked” by tying the WP pin HIGH.
EEPROM INADVERTENT WRITE PROTECTION
When RESET/RESET goes active as a result of a low
voltage condition or Watchdog Timer Time Out, any in-
progress communications are terminated. While
RESET/RESET is active, no new communications are
allowed and no nonvolatile write operation can start.
Nonvolatile writes in-progress when RESET/RESET
goes active are allowed to finish.
Additional protection mechanisms are provided with
memory Block Lock and the Write Protect (WP) pin.
These are discussed elsewhere in this document.
V_CC THRESHOLD RESET PROCEDURE
The X4163, X4165 is shipped with a standard V_CC
threshold (V_TRIP) voltage. This value will not change
over normal operating and storage conditions. How-
ever, in applications where the standard V_TRIP is not
exactly right, or if higher precision is needed in the
V_TRIP value, the X4163, X4165 threshold may be
adjusted. The procedure is described below, and uses
the application of a nonvolatile control signal.
Figure 1. Set V_TRIP Level Sequence (V_CC = desired V_TRIP values WEL bit set)
WP
SCL
SDA
V_P = 12-15V
01234567 01234567
0 1 23 4 56 7
0123456 7
A0h
00h
01h
00h
5
FN8120.2
November 26, 2007