CD40106BMS Datasheet, PDF (5/9 Pages) Intersil Corporation – CMOS Hex Schmitt Triggers

Specifications CD40106BMS
TABLE 6. APPLICABLE SUBGROUPS
CONFORMANCE GROUP
MIL-STD-883
METHOD
GROUP A SUBGROUPS
Group B
Subgroup B-5
Sample 5005
1, 2, 3, 7, 8A, 8B, 9, 10, 11, Deltas
Subgroup B-6
Sample 5005
1, 7, 9
Group D
Sample 5005
1, 2, 3, 8A, 8B, 9
NOTE: 1. 5% Parameteric, 3% Functional; Cumulative for Static 1 and 2.
READ AND RECORD
Subgroups 1, 2, 3, 9, 10, 11
Subgroups 1, 2 3
CONFORMANCE GROUPS
Group E Subgroup 2
TABLE 7. TOTAL DOSE IRRADIATION
MIL-STD-883
METHOD
TEST
PRE-IRRAD
POST-IRRAD
5005
1, 7, 9
Table 4
READ AND RECORD
PRE-IRRAD
POST-IRRAD
1, 9
Table 4
TABLE 8. BURN-IN AND IRRADIATION TEST CONNECTIONS
OSCILLATOR
FUNCTION
OPEN
GROUND
VDD
9V ± -0.5V
50kHz
25kHz
Static Burn-In 1 2, 4, 6, 8, 10, 12 1, 3, 5, 7, 9, 11, 13
14
Note 1
Static Burn-In 2 2, 4, 6, 8, 10, 12
7
Note 1
1, 3, 5, 9, 11,
13, 14
Dynamic Burn-
-
In Note 1
7
14
2, 4, 6, 8, 10, 12 1, 3, 5, 9, 11, 13
Irradiation
2, 4, 6, 8, 10, 12
7
Note 2
1, 3, 5, 9, 11,
13, 14
NOTES:
1. Each pin except VDD and GND will have a series resistor of 10K ± 5%, VDD = 18V ± 0.5V
2. Each pin except VDD and GND will have a series resistor of 47K ± 5%; Group E, Subgroup 2, sample size is 4 dice/wafer, 0 failures,
VDD = 10V ± 0.5V
Typical Performance Characteristics
AMBIENT TEMPERATURE (T_A) = +25^oC
AMBIENT TEMPERATURE (T_A) = +25^oC
30
GATE-TO-SOURCE VOLTAGE (VGS) = 15V
25
20
15
10V
10
5
5V
0
5
10
15
DRAIN-TO-SOURCE VOLTAGE (VDS) (V)
FIGURE 2. TYPICAL OUTPUT LOW (SINK) CURRENT
CHARACTERISTICS
15.0
GATE-TO-SOURCE VOLTAGE (VGS) = 15V
12.5
10.0
10V
7.5
5.0
2.5
5V
0
5
10
15
DRAIN-TO-SOURCE VOLTAGE (VDS) (V)
FIGURE 3. MINIMUM OUTPUT LOW (SINK) CURRENT
CHARACTERISTICS
7-1331