LMH6505 Datasheet, PDF (4/18 Pages) National Semiconductor (TI) – Wideband, Low Power, Linear-in-dB, Variable Gain Amplifier

Note 7: Slew rate is the average of the rising and falling slew rates.
Note 8: Typical values represent the most likely parametric norm as determined at the time of characterization. Actual typical values may vary over time and will
also depend on the application and configuration. The typical values are not tested and are not guaranteed on shipped production material.
Note 9: Limits are 100% production tested at 25°C. Limits over the operating temperature range are guaranteed through correlations using the Statistical Quality
Control (SQC) method.
Note 10: Positive current corresponds to current flowing into the device.
Note 11: Drift is determined by dividing the change in parameter distribution at temperature extremes by the total temperature change.
Note 12: +PSRR definition: [|ΔV_OUT/ΔV⁺| / A_V], −PSRR definition: [|ΔV_OUT/ΔV^−| / A_V] with 0.1V input voltage. ΔV_OUT is the change in output voltage with offset
shift subtracted out.
Note 13: Gain/Phase normalized to low frequency value at 25°C.
Note 14: Gain/Phase normalized to low frequency value at each setting.
Note 15: Flat Band Attenuation (Relative To Max Gain) Range Definition: Specified as the attenuation range from maximum which allows gain flatness specified
(either ±0.2 dB or ±0.1 dB), relative to A_VMAX gain. For example, for f < 30 MHz, here are the Flat Band Attenuation ranges:
±0.2 dB: 19.7 dB down to -6.3 dB = 26 dB range
±0.1 dB: 19.7 dB down to 10.2 dB = 9.5 dB range
Connection Diagram
8-Pin SOIC/MSOP
Ordering Information
Package
8-Pin SOIC
8-Pin MSOP
Part Number
LMH6505MA
LMH6505MAX
LMH6505MM
LMH6505MMX
Top View
20171001
Package Marking
LMH6505MA
AZ2A
Transport Media
95 Units/Rail
2.5k Units Tape and Reel
1k Units Tape and Reel
3.5k Units Tape and Reel
NSC Drawing
M08A
MUA08A
www.national.com
4