HC5509A1R3060 Datasheet, PDF (4/10 Pages) Intersil Corporation – SLIC Subscriber Line Interface Circuit

HC5509A1R3060
Electrical Specifications
Unless Otherwise Specified, Typical Parameters are at T_A = 25^oC, Min-Max Parameters are over Oper-
ating Temperature Range, V_B- = -48V, V_B+ = +5V, AG = BG = 0V. All AC Parameters are specified at
600Ω 2-Wire terminating impedance. (Continued)
PARAMETER
TEST CONDITIONS
MIN
TYP MAX UNITS
Fault Currents
TIP to Ground
-
38
45
mA
RING to Ground
-
54
60
mA
TIP and RING to Ground
-
85
95
mA
Switch Hook Detection Threshold
-
12
15
mA
Ground Key Detection Threshold
Thermal ALARM Output
9.5
13.5 17.5
mA
Safe Operating Die Temperature Exceeded
140
-
160
o_C
Ring Trip Comparator Threshold
See Typical Applications for more information
9.5
13.5 17.5
mA
Dial Pulse Distortion
-
0.1
0.5
ms
Relay Driver Outputs
On Voltage V_OL
Off Leakage Current
TTL/CMOS Logic Inputs (RC, PD, RS, TST,
PRI)
Logic ‘0’ V_IL
Logic ‘1’ V_IH
Input Current (RC, PD, RS, TST, PRI)
Logic Outputs
Logic ‘0’ V_OL
Logic ‘1’ V_OH
Power Dissipation On Hook
I_B+
I_B-
UNCOMMITTED OP AMP PARAMETERS
I_OL (PR) = 60mA, I_OL (RD) = 60mA
V_OH = 13.2V
0V ≤ V_IN ≤ 5V
I_LOAD = 800µA
I_LOAD = 40µA
Relay Drivers Off
V_B+ = +5.25V, V_B- = -58V, R_LOOP = ∞
V_B+ = +5.25V, V_B- = -58V, R_LOOP = ∞
-
0.2
0.5
V
-
±10
±100
µA
-
-
0.8
V
2.0
-
5.5
V
-
-
±100
µA
-
0.1
0.5
V
2.7
-
-
V
-
200
-
mW
-
-
6
mA
-6
-
-
mA
Input Offset Voltage
-
±5
-
mV
Input Offset Current
-
±10
-
nA
Differential Input Resistance
(Note 2)
-
1
-
MΩ
Output Voltage Swing
Small Signal GBW
R_L = 10kΩ
-
±3
-
V_P-P
-
1
-
MHz
NOTES:
3. Absolute maximum ratings are limiting values, applied individually, beyond which the serviceability of the circuit may be impaired. Func-
tional operability under any of these conditions is not necessarily implied.
4. These parameters are controlled by design or process parameters and are not directly tested. These parameters are characterized upon
initial design release, upon design changes which would affect these characteristics, and at intervals to assure product quality and spec-
ification compliance.
5. Application limitation based on maximum switch hook detect limit and metallic currents. Not a part limitation.
4