HC5509A1R3060 Datasheet, PDF (2/10 Pages) Intersil Corporation – SLIC Subscriber Line Interface Circuit

HC5509A1R3060
Absolute Maximum Ratings T_A = 25^oC
Relay Drivers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to +15V
Maximum Supply Voltages
(V_B+) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to +7V
(V_B+)-(V_B-) . . . . . .
Junction Temperature
......
Plastic
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
. +75V
150^oC
Lead Temperature (Soldering 10s) . . . . . . . . . . . . . . . . . . . . . 300^oC
Operating Conditions
Operating Temperature Range
HC4P5509A1R3060 . . . . . . . . . . . . . . . . . . . . . . . . . .0^oC to 75^oC
Storage Temperature Range . . . . . . . . . . . . . . . . . . -65^oC to 150^oC
Relay Drivers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +5V to +12V
Positive Power Supply (V_B+) . . . . . . . . . . . . . . . . . . . . . . . +5V ±5%
Negative Power Supply (V_B-) . . . . . . . . . . . . . . . . . . . . -42V to -58V
Loop Resistance (R_L) . . . . . . . . . . . . . . . . . 200Ω to 1750Ω (Note 2)
Thermal Information
Thermal Resistance (Typical, Note 1)
PLCC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . .
θ_JA (^oC/W)
67
Die Characteristics
Transistor Count . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 224
Diode Count . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
Die Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 174 x 120
Substrate Potential . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Connected
Process . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Bipolar-DI
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. θ_JA is measured with the component mounted on an evaluation PC board in free air.
2. May be extended to 1900Ω with application circuit.
Electrical Specifications
Unless Otherwise Specified, Typical Parameters are at T_A = 25^oC, Min-Max Parameters are over Oper-
ating Temperature Range, V_B- = -48V, V_B+ = +5V, AG = BG = 0V. All AC Parameters are specified at
600Ω 2-Wire terminating impedance.
PARAMETER
TEST CONDITIONS
MIN
TYP MAX UNITS
AC TRANSMISSION PARAMETERS
RX Input Impedance
300Hz to 3.4kHz (Note 3)
-
100
-
kΩ
TX Output Impedance
300Hz to 3.4kHz (Note 3)
-
-
20
Ω
4-Wire Input Overload Level
300Hz to 3.4kHz R_L = 1200Ω,
600Ω Reference
+1.5
-
-
V_PEAK
2-Wire Return Loss
SRL LO
Matched for 600Ω (Note 3)
26
35
-
dB
ERL
30
40
-
dB
SRL HI
30
40
-
dB
2-Wire Longitudinal to Metallic Balance
Off Hook
Per ANSI/IEEE STD 455-1976 (Note 3) 300Hz 58
63
-
dB
to 3400Hz
4-Wire Longitudinal Balance
Off Hook
300Hz to 3400Hz (Note 3)
50
55
-
dB
Low Frequency Longitudinal Balance
Longitudinal Current Capability
Insertion Loss
2-Wire/4-Wire
R.E.A. Test Circuit
I_LINE = 40mA T_A = 25^oC (Note 3)
I_LINE = 40mA T_A = 25^oC (Note 3)
0dBm at 1kHz, Referenced 600Ω
-
-
-67
dBmp
-
-
23
dBrnC
-
-
30
mA_RMS
-6.22 -6.02 -5.82
dB
4-Wire/2-Wire
-
±0.05 ±0.2
dB
4-Wire/4-Wire
-6.22 -6.02 -5.82
dB
2