HC-5509B3999-003 Datasheet, PDF (4/10 Pages) Intersil Corporation – SLIC Subscriber Line Interface Circuit

HC-5509B3999-003
Electrical Specifications
Unless Otherwise Specified, Typical Parameters are at T_A = +25^oC, Min-Max Parameters are Over Operating
Temperature Range, V_B- = -48V, V_B+ = +5V, AG = DG = BG = 0V. All AC Parameters are specified at 600Ω
2-Wire Terminating Impedance. (Continued)
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX UNITS
Logic Outputs
Logic ‘0’ V_OL
Logic ‘1’ V_OH
Power Dissipation On Hook
I_B+
I_B-
UNCOMMITED OP AMP PARAMETERS
I_LOAD = 800µA
I_LOAD = 40µA
Relay Drivers Off
V_B+ = +5.25V, V_B- = -58V, R_LOOP = ∞
V_B+ = +5.25V, V_B- = -58V, R_LOOP = ∞
-
0.1
0.5
V
2.7
-
-
V
-
200
-
mW
-
-
6
mA
-6
-
-
mA
Input Offset Voltage
-
±5
-
mV
Input Offset Current
-
±10
-
nA
Differential Input Resistance
(Note 3)
-
1
-
MΩ
Output Voltage Swing
Small Signal GBW
R_L = 10kΩ
(Note 3)
-
±3
-
V_P-P
-
1
-
MHz
NOTES:
1. Absolute maximum ratings are limiting values, applied individually, beyond which the serviceability of the circuit may be impaired. Functional
operability under any of these conditions is not necessarily implied.
2. May Be Extended to 1900Ω With Application Circuit.
3. These parameters are controlled by design or process parameters and are not directly tested. These parameters are characterized upon initial
design release, upon design changes which would affect these characteristics, and at intervals to assure product quality and specification
compliance.
4