ISL24011 Datasheet, PDF (3/9 Pages) Intersil Corporation – High Voltage TFT-LCD Logic Driver

ISL24011
Absolute Maximum Ratings (T_A = 25°C)
Driver Positive Supply Voltage Range, (V_ON) . . . . . . . . +5V to +40V
Power Supply Voltage Range, (V_ON to V_OFF). . . . . . . +10V to +60V
Negative Supply Voltage Range, (V_OFF) . . . . . . . . . . . . . -20V to -5V
Supply Turn-On Slew Rate . . . . . . . . . . . . . . . . . . . . . . . . . . 10V/µs
Input Voltage Range, All Inputs . . . . . . . . . . . . . . . . . . -0.5V to 5.5V
Output Voltage Range, All Outputs . . . . . V_OFF -0.5V to V_ON +0.5V
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (°C/W)
20 Ld TSSOP Package . . . . . . . . . . . . . . . . . . . . . .
140
I_OUT (continuous, all 8 channels . . . . . . . . . . . . . . . . . . . . . . . 80mA
T_AMBIENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-40°C to +85°C
T_JUNCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-40°C to +150°C
T_STORAGE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-65°C to +150°C
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
1. θ_JA is measured with the component mounted on a HIGH effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: T_J = T_C = T_A
Electrical Specifications V_ON = 22V, V_OFF = -5V, T_A = -40°C to +85°C Unless Otherwise Specified. Typical values tested at 25°C
PARAMETER
DESCRIPTION
CONDITION
MIN
TYP
MAX
UNIT
Power Supplies Recommended Operating Voltages
I(V_ON)
Supply Current
I(V_OFF)
Supply Current
All Inputs low or high
No load
V_ON = V_ON1 + V_ON2
All Inputs low or high
No load
-5
(V_OFF)
22
V
(V_ON)
5.0
8.0
mA
-8.0
-5.0
mA
I_IN
Input Leakage
Each Input low or high
High = 1.8V, Low = 0.8V
-10
± 3.5
10
µA
VOH
High Level Output Voltage IOH = -100µA
(V_ON - 1.5V)
21.2
V
V_ON = 22V
RL = 4700pF in parallel with 5kΩ
VOL
Low Level Output Voltage
IOH = +100µA
V_OFF = -5V
RL = 4700pF in parallel with 5kΩ
-4.3
(V_OFF +
V
1.5V)
VIH
High Level Input Voltage
1.8
V
VIL
Low Level Input Voltage
0.8
V
tplh
Low to High Prop Delay 50% to 50%, Tested with
RL = 4700pF in parallel with 5kΩ,
f = 50kHz
190
400
ns
tphl
High to Low Prop Delay Measured at 50% to 50%
f = 50kHz
RL = 4700pF in parallel with 5kΩ
230
400
ns
ttlh
Rise Time
Measured at 10% to 90%
f = 50kHz
RL = 4700pF in parallel with 5kΩ
260
400
ns
tthl
Fall Time
Measured at 10% to 90%
f = 50kHz
RL = 4700pF in parallel with 5kΩ
290
500
ns
3
FN6196.0
October 21, 2005