ISL72026SEH Datasheet, PDF (2/18 Pages) Intersil Corporation – 3.3V Radiation Tolerant CAN Transceiver, 1Mbps, Listen Mode, Loopback

ISL72026SEH
Ordering Information
ORDERING / SMD
NUMBER (Note 1)
PART NUMBER
(Note 2)
TEMPERATURE RANGE
(°C)
PACKAGE
(RoHS Compliant)
PACKAGE
DRAWING #
5962L1522801VXC
ISL72026SEHVF
-55 to +125
8 Ld Ceramic Flat Pack
K8.A
ISL72026SEHF/PROTO
ISL72026SEHF/PROTO
-55 to +125
8 Ld Ceramic Flat Pack
K8.A
5962L1522801V9A
ISL72026SEHVX
-55 to +125
Die
ISL72026SEHX/SAMPLE
ISL72026SEHX/SAMPLE
-55 to +125
Die
ISL72026SEHEVAL1Z
Evaluation Board
NOTES:
1. Specifications for Radiation Tolerant QML devices are controlled by the Defense Logistics Agency Land and Maritime (DLA). The SMD numbers listed
in the “Ordering Information” table must be used when ordering.
2. These Intersil Pb-free Hermetic packaged products employ 100% Au plate - e4 termination finish, which is RoHS compliant and compatible with both
SnPb and Pb-free soldering operations.
SPEC
Loopback Feature
VREF Output
Listen Mode
Shutdown Mode
VTHRLM
VTHFLM
VHYSLM
Supply Current, Listen Mode
Supply Current, Shutdown Mode
VREF Leakage Current
N/A: Not Applicable
TABLE 1. ISL7202xSEH PRODUCT FAMILY FEATURE TABLE
ISL72026SEH
ISL72027SEH
Yes
No
No
Yes
Yes
Yes
No
No
1150mV (Max)
1150mV (Max)
525mV (Min)
525mV (Min)
50mV (Min)
50mV (Min)
2mA (Max)
2mA (Max)
N/A
N/A
N/A
±25µA (Max)
Pin Configuration
ISL72026SEH
(8 LD CERAMIC FLATPACK)
TOP VIEW
D
Note: The package lid is GND
tied to ground.
VCC
R
1
8
2
7
3
6
4
5
RS
CANH
CANL
LBK
ISL72028SEH
No
Yes
No
Yes
N/A
N/A
N/A
N/A
50µA (Max)
±25µA (Max)
Pin Descriptions
PIN
NUMBER PIN NAME
FUNCTION
1
D CAN driver digital input. The bus states are LOW = Dominant and HIGH = Recessive. Internally tied HIGH.
2
GND Ground connection.
3
VCC System power supply input (3.0V to 3.6V). The typical voltage for the device is 3.3V.
4
R CAN Data Receiver Output. The bus states are LOW = Dominant and HIGH = Recessive.
8
RS A resistor to GND from this pin controls the rise and fall time of the CAN output waveform. Drive RS HIGH to put into Listen Mode.
6
CANL CAN bus line for low level output
7
CANH CAN bus line for high level output
5
LBK A HIGH on this pin places CANH and CANL pins in a high impedance state. The rest of the circuit remains active so that the TX
and RX can loopback diagnostic information. Internally tied LOW.
Submit Document Feedback
2
FN8762.1
November 9, 2015