FMCE-0828_11 Datasheet, PDF (9/11 Pages) Interpoint Corporation Company – EMI Input Filters 28 Volt input – 8 Amp

Crane Aerospace & Electronics Power Solutions
FMCE-0828 EMI Input Filters – Cases
28 Volt input – 8 Amp
TOP VIEW CASE U*
Side-leaded case
*Designator “SL” required in Case Option position of model number
Angled corner
indicates pin one.
1.505 (38.23) max.
1.380 (35.05)
1.250 (31.75)
1.050 (26.67)
0.850 (21.59)
0.650 (16.51)
0.450 (11.43)
0.250 (6.35)
0.120 (3.05)
0.000
0.23 (5.8) Pin Length
1
2
3
4
5
6
Seam Seal
0.128 dia
(3.25).
0.040 dia
(1.02)
12
11
10
9
8
7
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device. Solder pins
individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold, compression glass seal
Seal Hole: 0.100 ±0.002 (2.54 ±0.05)
Case U EMI SL, Rev F, 20100401
Please refer to the numerical dimensions for accuracy. All information is believed to
be accurate, but no responsibility is assumed for errors or omissions. Interpoint
reserves the right to make changes in products or specifications without notice.
Copyright © 1999-2010 Interpoint Corp. All rights reserved.
Figure 13: Case U
www.craneae.com/interpoint
Page 9 of 11
FMCE-0828 Rev J - 2011.09.08