FMCE-0828 Datasheet, PDF (8/11 Pages) Interpoint Corporation Company – Attenuation to 60 dB at 500 kHz, typical MIL-STD-461C CE03

Crane Aerospace & Electronics Power Solutions
FMCE-0828 EMI Input Filters – Cases
28 Volt input – 8 Amp
BOTTOM VIEW CASE J6
Flanged cases: Designator "F" required in Case Option position of model number.
Seam Seal
1.350 max. (34.29)
1.170 (29.72)
0.040 dia.
(1.02)
0.670
(17.02)
0.170
(4.32)
0.000
Dot on top of case indicates pin one.
1
2
5
4
3
2 x Dia 0.162 ±0.002
(4.11 ±0.05)
2 x R 0.170 (4.32)
(2.720 max (69.09))
Flange thickness: 0.060 (1.52)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device. Solder pins
individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold ceramic seal.
Seal Hole: 0.120 ±0.002 (3.04 ±0.05)
Case J6 FMCE-0828, Rev C, 20100419
Please refer to the numerical dimensions for accuracy. All information is believed to
be accurate, but no responsibility is assumed for errors or omissions. Interpoint
reserves the right to make changes in products or specifications without notice.
Copyright © 1999-2010 Interpoint Corp. All rights reserved.
Figure 12: Case J6
www.interpoint.com
Page 8 of 11
FMCE-0828 Rev E - 20100427