FMCE-0828 Datasheet, PDF (7/11 Pages) Interpoint Corporation Company – Attenuation to 60 dB at 500 kHz, typical MIL-STD-461C CE03

Crane Aerospace & Electronics Power Solutions
FMCE-0828 EMI Input Filters – Cases
28 Volt input – 8 Amp
BOTTOM VIEW CASE F5
Seam Seal
1.350 max. (34.29)
Squared corner and dot
on top of case indicates pin one
1.170
(29.72)
0.040 dia.
1
2
(1.02)
5
0.170
(4.32)
0.000
4
3
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold ceramic seal
Seal hole 0.120 ±0.002 (2.34 ± 0.05)
Case F5 FMCE-0828, Rev C, 20100412
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2010 Interpoint Corp. All rights reserved.
Figure 11: Case F5
www.interpoint.com
Page 7 of 11
FMCE-0828 Rev E - 20100427