TC1782 Datasheet, PDF (84/130 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1782
Electrical ParametersDC Parameters
Table 27 ADC Parameters (cont’d)
Parameter
Symbol
Values
Unit Note /
Min. Typ. Max.
Test Condition
Resistance of the
reference voltage input
path
R_AREF
−
CC
500 1000 Ohm
Sample time
t_S CC 2
−
Calibration time after bit t_CAL CC −
−
ADC_GLOBCFG.SUCAL
is set
Total Unadjusted
Error^6)5)12)
TUE CC -4
−
Analog reference ground²⁾ V_AGND0 V_SSM - −
SR
0.05
257
4352
T_ADCI
cycle
s
4¹³⁾
V_AREF0
-1
LSB
V
ADC
resolution= 12-
bit
Analog input voltage
V_AIN SR V_AGND0 −
Analog reference voltage²⁾ V_AREF0 V_AGND0 −
SR
+1
V_AREF0 V
V_DDM + V
0.05¹⁴⁾
15)
Analog reference voltage
range⁶⁾⁵⁾²⁾
V_AREF0 -
V_AGND0
SR
V_DDM/2 −
V_DDM + V
0.05
1) The sampling capacity of the conversion C-network is pre-charged to V_AREF0/2 before the sampling moment.
Because of the parasitic elements the voltage measured at AINx can deviate from V_AREF0/2.
2) Applies to AINx, when used as auxiliary reference input.
3) This represents an equivalent switched capacitance. This capacitance is not switched to the reference voltage
at once. Instead smaller capacitances are successively switched to the reference voltage.
4) The sum of DNL/INL/GAIN/OFF errors does not exceed the related TUE total unadjusted error.
5) If a reduced analog reference voltage between 1V and V_DDM / 2 is used, then there are additional decrease in
the ADC speed and accuracy.
6) If the analog reference voltage range is below V_DDM but still in the defined range of V_DDM / 2 and V_DDM is used,
then the ADC converter errors increase. If the reference voltage is reduced by the factor k (k<1),
TUE,DNL,INL,Gain, and Offset errors increase also by the factor 1/k.
7) If the analog reference voltage is > V_DDM, then the ADC converter errors increase.
8) For 10-bit conversions the error value must be multiplied with a factor 0.25.
9) For 8-bit conversions the error value must be multiplied with a factor 0.0625.
10) For a conversion time of 1 µs a rms value of 85µA result for I_AREF0.
11) The leakage current definition is a continuos function, as shown in figure ADCx Analoge Input Leakage. The
numerical values defined determine the characteristic points of the given continuous linear approximation -
they do not define step function.
Data Sheet
77
V 1.4.1, 2014-05