V23836-C18-C63 Datasheet, PDF (8/13 Pages) Infineon Technologies AG – 1x9 Transceiver with Duplex SC Receptacle Single Mode 1300 nm 21 km SONET OC-3 / SDH STM-1

V23836-C18-C63
V23836-C18-C363
Technical Data
Receiver Electro-Optical Characteristics
Parameter
Sensitivity (Average Power)¹⁾
5V
3.3 V
Saturation (Average Power)
Signal Detect Assert Level²⁾
Signal Detect Deassert Level³⁾
Signal Detect Hysteresis
Signal Detect Assert Time
Signal Detect Deassert Time
Output Low Voltage⁴⁾
Output High Voltage⁴⁾
Output Data Rise/Fall Time,
20% - 80%
Output SD Rise/Fall Time
Symbol
P_IN
P_SAT
P_SDA
P_SDD
P_SDA
–P_SDD
t_ASS
t_DAS
V_OL–V_CC
V_OH–V_CC
t_R, t_F
min.
–8
–44
1
–2000
–1100
Values
typ.
max.
–36
–28
–31
–34
2
5
75
100
80
350
–1580
–740
1.1
10
40
Unit
dBm
dBm
dBm
dBm
dB
µs
µs
mV
mV
ns
ns
1) _{Minimum average optical power at which the BER is less than 1x10}–10 _{or lower. Measured with a 2}23_{–1 NRZ}
PRBS as recommended by ANSI T1E1.2, SONET OC-3 and ITU-T G.957. BOL value –31 dBm max.
2) _{An increase in optical power of data signal above the specified level will cause the Signal Detect to switch from}
a low state to a high state.
3) _{A decrease in optical power of data signal below the specified level will cause the Signal Detect to switch from}
a high state to a low state.
4) _{DC/DC, PECL for Signal Detect, PECL compatible. Load is 50 Ω into VCC–2 V for data, 510 Ω to VEE for Signal}
Detect. Measured under DC conditions. For dynamic measurements a tolerance of 50 mV should be added.
V_CC = 5 V/3.3 V. T_AMB = 25°C.
Preliminary Product Information
8
2004-02-13