V23826-C18-C366 Datasheet, PDF (8/15 Pages) Infineon Technologies AG – DC/DC (3.3 V) Single Mode 155 MBd ATM/SDH/SONET 1x9 Transceiver Extended Temperature Range

V23826-C18-C366
Technical Data
Receiver Electro-Optical Characteristics
Parameter
Symbol
Limit Values
Unit
Sensitivity (Average Power)¹⁾
Saturation (Average Power)
Signal Detect Assert Level²⁾
Signal Detect Deassert Level³⁾
Signal Detect Hysteresis
Signal Detect Assert Time
Signal Detect Deassert Time
Output Low Voltage⁴⁾
Output High Voltage⁴⁾
Output Data Rise/Fall Time,
20%–80%
P_IN
P_SAT
P_SDA
P_SDD
P_SDA –
P_SDD
t_ASS
t_DAS
V_OL - V_CC
V_OH - V_CC
t_R, t_F
min.
–8
–44
1
–1950
–1025
typ.
–36
–37.5
–40
2.5
max.
–31
dBm
–34
6
dB
100
µs
350
–1620 mV
–720
375
ps
Output SD Rise/Fall Time
40
ns
1) _{Minimum average optical power at which the BER is less than 1x10}-10 _{or lower. Measured with a 2}23 _{- 1 NRZ}
PRBS as recommended by ANSI T1E1.2, SONET OC-3 and ITU-T G.957.
2) _{An increase in optical power of data signal above the specified level will cause the SIGNAL DETECT to switch}
from a Low state to a High state.
3) _{A decrease in optical power of data signal below the specified level will cause the SIGNAL DETECT to switch}
from a High state to a Low state.
4) _{DC/DC, PECL for Signal Detect, PECL compatible. Load is 50 Ω into VCC – 2 V for data, 500 Ω to VEE for Signal}
Detect. Measured under DC conditions. For dynamic measurements a tolerance of 50 mV should be added.
V_CC = 3.3 V. T_AMB = 25°C.
Data Sheet
8
2000-04-01