V23826-C18-C366 Datasheet, PDF (3/15 Pages) Infineon Technologies AG – DC/DC (3.3 V) Single Mode 155 MBd ATM/SDH/SONET 1x9 Transceiver Extended Temperature Range

V23826-C18-C366
Description
Description
The Infineon single mode ATM transceiver complies with the ATM Forum's Network
Compatible ATM for Local Network Applications document and ANSI's Broadband ISDN
- Customer Installation Interfaces, Physical Media Dependent Specification, T1.646-
1995, Bellcore - SONET OC-3 / IR-1 and ITU-T G. 957 STM-1 / S.1.1.
ATM was developed to facilitate solutions in multimedia applications and real time
transmission. The data rate is scalable, and the ATM protocol is the basis of the
broadband public networks being standardized in the International Telecommunications
Union (ITU), the former International Telegraph and Telephone Consultative Committee
(CCITT). ATM can also be used in local private applications.
The Infineon single mode ATM transceiver is a single unit comprised of a transmitter, a
receiver, and an SC receptacle. This design frees the customer from many alignment
and PC board layout concerns. The module is designed for low cost WAN applications.
It can be used as the network end device interface in workstations, servers, and storage
devices, and in a broad range of network devices such as bridges, routers, and intelligent
hubs, as well as wide area ATM switches.
This transceiver operates at 155.520 Mbit/s from a single power supply (+3.3 V). The
differential data inputs and outputs are PECL compatible.
Functional Description
This transceiver is designed to transmit serial data via single mode cable.
Signal Monitor and
Automatic Shut-Down
LEN
Laser Coupling Unit
TD
Laser ^ISM
TD
Driver
e/o
Laser
Power
Control
Monitor
RD
RD
Receiver
SD
o/e
Single Mode Fiber
RX Coupling Unit
o/e
Figure 2 Functional Diagram
Data Sheet
3
2000-04-01