V23826-K15-C13 Datasheet, PDF (7/16 Pages) Infineon Technologies AG – Single Mode 1300 nm 1.0625 GBd Fibre Channel 1.3 Gigabit Ethernet 1x9 Transceiver

V23826-K15-Cxx/Cxxx
Technical Data
Receiver Electro-Optical Characteristics
Parameter
Symbol
Limit Values
Unit
min.
typ.
max.
Sensitivity (Average Power)¹⁾ P_IN
–22
Saturation (Average Power)
P_SAT
Signal Detect Assert Level²⁾
P_SDA
Signal Detect Deassert Level³⁾ P_SDD
–30
Signal Detect Hysteresis
P_SDA
1.5
–P_SDD
Signal Detect Assert Time
t_ASS
Signal Detect Deassert Time t_DAS
Output Low Voltage⁴⁾
V_OL–V_CC –1950
Output High Voltage⁴⁾
V_OH–V_CC –1025
Signal Detect Output
Low V_SDL
Voltage AC/AC TTL⁵⁾
High V_SDH
2.0
Data Output
Differential Voltage⁶⁾
V_DIFF
0.5
–20
dBm
–3
–20
dB
100
µs
350
–1600 mV
–720
0.5
V
0.9
Output Data Rise/Fall Time,
20% - 80%
t_R, t_F
375
ps
Return Loss of Receiver
A_RL
12
dB
1) _{Minimum average optical power at which the BER is less than 1x10E–12 or lower. Measured with a 2}7_{–1 NRZ}
PRBS and ER = 9 dB. Output of single mode fiber 9 µm diameter.
2) _{An increase in optical power above the specified level will cause the SIGNAL DETECT output to switch from}
a Low state to a High state.
3) _{A decrease in optical power below the specified level will cause the SIGNAL DETECT to change from a High}
state to a Low state.
4) _{DC/DC, AC/DC for data. DC/DC, AC/DC, AC/AC PECL for Signal Detect. PECL compatible. Load is 50 W into}
V_CC–2 V for data, 500 W to V_EE for Signal Detect. Measured under DC conditions. For dynamic measurements
a tolerance of 50 mV should be added. V_CC = 3.3 V/5 V. T_AMB = 25°C.
5) _{Max. output current high: –0.4 mA (drive current) low: +2.0 mA (sink current)}
6) _{AC/AC for data. Load 50 W to GND or 100 W differential. For dynamic measurement a tolerance of 50 mV}
should be added.
Data Sheet
7
2000-03-09