V23826-K15-C13 Datasheet, PDF (3/16 Pages) Infineon Technologies AG – Single Mode 1300 nm 1.0625 GBd Fibre Channel 1.3 Gigabit Ethernet 1x9 Transceiver

V23826-K15-Cxx/Cxxx
Description
Description
The Infineon single mode transceiver is based on the Physical Medium Depend (PMD)
sublayer and baseband medium, type 1000BASE-LX (Long Wavelength Laser)
(IEEE 802.5) and complies with the Fibre Channel Physical and Signaling Interface (FC-
PH), ANSI XSI TT Fibre Channel Physical Standard Class 100-SM-LL-I, latest Revision.
The appropriate fiber optic cable is 9 µm (mode field diameter) single mode fiber (up to
10 km) with Duplex SC connector.
The Infineon single mode transceiver is a single unit comprised of a transmitter, a
receiver, and an SC receptacle. This design frees the customer from many alignment
and PC board layout concerns. The module is designed for low cost LAN, WAN and
Gigabit Ethernet applications. It can be used as the network end device interface in
mainframes, workstations, servers, and storage devices, and in a broad range of
network devices such as bridges, routers, intelligent hubs, and local and wide area
switches.
This transceiver operates at 1.0625 and 1.3 Gbit/s from a single power supply (+5 V or
3.3 V). The full differential data inputs and outputs are PECL compatible.
Functional Description
This transceiver is designed to transmit serial data via single mode or multimode cable.
SignalM onitorand
Autom atic Shut-D ow n
LEN
LaserCoupling U nit
TD
Laser ^{ISM *}
TD
D river
e/o
Laser
Pow er
Control
M onitor
RD
RD
Receiver
SD
o/e
Single M ode Fiber
RX Coupling U nit
o/e
*D C/D C Version only
Figure 2 Functional Diagram
The receiver component converts the optical serial data into PECL compatible electrical
data (RD and RDnot). The Signal Detect (SD, active high) shows whether an optical
signal is present.
The transmitter converts electrical PECL compatible serial data (TD and TDnot) into
optical serial data.
Data Sheet
3
2000-03-09