XC164N-16F Datasheet, PDF (54/73 Pages) Infineon Technologies AG – 16-Bit Single-Chip Microcontroller with C166SV2 Core

XC164N
Derivatives
Electrical Parameters
1) An output current above |I_OXnom| may be drawn from up to three pins at the same time.
For any group of 16 neighboring port output pins the total output current in each direction (ΣI_OL and Σ-I_OH) must
remain below 50 mA.
Table 13 Power Consumption XC164N (Operating Conditions apply)
Parameter
Power supply current (active)
with all peripherals active
Pad supply current
Idle mode supply current
with all peripherals active
Sleep and Power down mode
supply current caused by
leakage⁴⁾
Sym- Limit Values
bol _{Min. Max.}
I_DDI –
I_DDP –
I_IDX –
I_PDL5) –
15 +
2.6 × f_CPU
5
15 +
1.2 × f_CPU
128,000
× e^-α
Sleep and Power down mode I_PDM7) –
supply current caused by
leakage and the RTC running,
clocked by the main oscillator⁴⁾
0.6 +
0.02 × f_OSC
+ I_PDL
Unit Test Condition
mA f_CPU in [MHz]¹⁾²⁾
mA ³⁾
mA f_CPU in [MHz]²⁾
mA
V_DDI
=
V 6)
DDImax
T_J in [°C]
α=
4670 / (273 + T_J)
mA V_DDI = V_DDImax
f_OSC in [MHz]
1) During Flash programming or erase operations the supply current is increased by max. 5 mA.
2) The supply current is a function of the operating frequency. This dependency is illustrated in Figure 10.
These parameters are tested at V_DDImax and maximum CPU clock frequency with all outputs disconnected and
all inputs at V_IL or V_IH.
3) The pad supply voltage pins (V_DDP) mainly provides the current consumed by the pin output drivers. A small
amount of current is consumed even though no outputs are driven, because the drivers’ input stages are
switched and also the Flash module draws some power from the V_DDP supply.
4) The total supply current in Sleep and Power down mode is the sum of the temperature dependent leakage
current and the frequency dependent current for RTC and main oscillator (if active).
5) This parameter is determined mainly by the transistor leakage currents. This current heavily depends on the
junction temperature (see Figure 12). The junction temperature T_J is the same as the ambient temperature T_A
if no current flows through the port output drivers. Otherwise, the resulting temperature difference must be
taken into account.
6) All inputs (including pins configured as inputs) at 0 V to 0.1 V or at V_DDP - 0.1 V to V_DDP, all outputs (including
pins configured as outputs) disconnected. This parameter is tested at 25 °C and is valid for T_J ≥ 25 °C.
7) This parameter is determined mainly by the current consumed by the oscillator switched to low gain mode (see
Figure 11). This current, however, is influenced by the external oscillator circuitry (crystal, capacitors). The
given values refer to a typical circuitry and may change in case of a not optimized external oscillator circuitry.
Data Sheet
52
V1.2, 2006-08