V23818-C18-L47 Datasheet, PDF (5/17 Pages) Infineon Technologies AG – Small Form Factor Single Mode 1300 nm Multirate up to 155 Mbit/s Transceiver 2x5 Pinning with LC™ Connector

V23818-C18-Lxx/L4xx
Description
Description
This data sheet describes the Infineon single mode ATM transceiver, which complies
with the ATM Forum’s Network Compatible ATM for Local Network Applications
document and ANSI’s Broadband ISDN - Customer Installation Interfaces, Physical
Media Dependent Specification, T1E1.2, compliant to SONET OC-3, IR-1 (Telcordia
GR-253-CORE) and SDH STM-1/S-1.1 (ITU-T G.957).
This transceiver is also suitable for multirate applications. The performance at lower
datarates may vary from application to application and is link dependent. Refer to
Infineon Application Note 97 for more information.
ATM was developed to facilitate solutions in multimedia applications and real time
transmission. The data rate is scalable, and the ATM protocol is the basis of the
broadband public networks being standardized in the International Telecommunications
Union (ITU), the former International Telegraph and Telephone Consultative Committee
(CCITT). ATM can also be used in local private applications.
The Infineon single mode ATM transceiver is a single unit comprised of a transmitter, a
receiver, and an LC receptacle. This design frees the customer from many alignment
and PC board layout concerns. The module is designed for low cost LAN and WAN
applications. It can be used as the network end device interface in workstations, servers,
and storage devices, and in a broad range of network devices such as bridges, routers,
and intelligent hubs, as well as local and wide area ATM switches.
This transceiver operates at up to 155.520 Mbit/s from a single power supply (+3.3 V).
The full differential data inputs and outputs are LVPECL compatible.
Data Sheet
5
2003-06-06