V23818-C18-L47 Datasheet, PDF (11/17 Pages) Infineon Technologies AG – Small Form Factor Single Mode 1300 nm Multirate up to 155 Mbit/s Transceiver 2x5 Pinning with LC™ Connector

V23818-C18-Lxx/L4xx
Technical Data
Receiver Electro-Optical Characteristics
Receiver
Symbol
Limit Values
Unit
min.
typ.
max.
Sensitivity (Average Power)¹⁾ P_IN
–34
Saturation (Average Power)
P_SAT
–8
Signal Detect Assert Level²⁾
P_SDA
Signal Detect Deassert Level³⁾ P_SDD
–45
Signal Detect Hysteresis
P_SDA
3
–P_SDD
Signal Detect Assert Time
t_ASS
Signal Detect Deassert Time t_DAS
Data Output High Voltage
DC/DC ⁴⁾
V_OH–V_CC –1110
–29
–29
100
350
–650
dBm
dBm
dBm
dBm
dB
µs
µs
mV
Differential Data Output Voltage V_ODpk-pk 1000
Swing AC/AC
2000
mV
Data Output Low Voltage
DC/DC⁴⁾
V_OL–V_CC –1800
–1300 mV
Signal Detect Output High
Voltage LVPECL^{5) 6)}
V_SDH–V_EE V_CC
–1200
V_CC
mV
–820
Signal Detect Output Low
Voltage LVPECL^{5) 6)}
V_SDL–V_EE V_CC
–1900
V_CC
mV
–1580
Signal Detect Output High
V_SDH
2.4
V
Voltage LVTTL^{5) 7)}
Signal Detect Output Low
Voltage LVTTL^{5) 7)}
V_SDL
0.5
V
Output Data Rise/Fall Time,
20% - 80%
t_R, t_F
1
ns
Output SD Rise/Fall Time
t_R, t_F
40
ns
1) _{Minimum average optical power at which the BER is less than 1x10}–10_{. Measured with a 2}23_{–1 NRZ PRBS.}
Worst case receiver sensitivity at 25°C is –31 dBm (beginning of life).
2) _{An increase in optical power of data signal above the specified level will cause the Signal Detect to switch from}
a low state to a high state (high active output).
3) _{A decrease in optical power of data signal below the specified level will cause the Signal Detect to switch from}
a high state to a low state.
4) _{Load is 100 Ω differential.}
5) _{Measured under DC conditions at 25°C. For dynamic measurements a tolerance of 50 mV should be added.}
6) _{Only for V23818-C18-L3x/L436.}
7) _{Only for V23818-C18-L4x.}
Data Sheet
11
2003-06-06