V23806-A34-C2 Datasheet, PDF (5/5 Pages) Infineon Technologies AG – Single Mode FDDI 1x9 Transceiver with SC Receptacle

APPLICATION NOTE
Single Mode 1x9 Transceiver
L1
VCC-Tx
V_CC
C1
C2
R1
VEE
VEE
TxD
TxDN
9
R3
VEE
VCC-Rx
L2
V_CC
1
R5
R7
C3
C4
VEE
VEE
V_EE
RxD
RxDN
SD
C1/3 = 4.7 µF
C2/4 = 4.7 µF
L1/2 = 15 µH (L2 optional)*
R2
R4 _S2
S1
Top View
V_EE V_EE
TxV_EE ^Transceiver RxV_EE
DC coupling between ECL gates
R9
R8
R6
V_EE V_EE V_EE
R1/3/5/7 = 82 Ω
R2/4/6/8 = 127 Ω
R9
= 510 Ω
* Recommended choke is Siemens Matsushita B78108-S1153-K or B78148-S1153-K (Q_min=60, max. DC resistance=0.6 Ω).
The power supply filtering is recommended for good EMI per-
formance. Use short tracks from the inductor L1/L2 to the mod-
ule V_CC–RX/V_CC–TX. We recommend a V_EE plane under the
module for getting good EMI and sensitivity performance.
Reset is only possible if the power is turned off, and then on
again. V_CCTX switched below V_TH. Further application notes for
electrical interfacing are available upon request. Ask for App-
note 82.
Studs should be connected to this V_EE plane. The transceiver
contains an automatic shutdown circuit.
Application board available on request.
Published by Infineon Technologies AG
© Infineon Technologies AG 1999
All Rights Reserved
Attention please!
The information herein is given to describe certain components and shall not be
considered as warranted characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties
of non-infringement, regarding circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
Information
For further information on technology, delivery terms and conditions and prices
please contact the Infineon Technologies offices or our Infineon Technologies
Representatives worldwide - see our webpage at
www.infineon.com/fiberoptics
Warnings
Due to technical requirements components may contain dangerous substances.
For information on the types in question please contact your Infineon Technologies
offices.
Infineon Technologies Components may only be used in life-support devices or
systems with the express written approval of Infineon Technologies, if a failure of
such components can reasonably be expected to cause the failure of that
life-support device or system, or to affect the safety or effectiveness of that device
or system. Life support devices or systems are intended to be implanted in the
human body, or to support and/or maintain and sustain and/or protect human life.
If they fail, it is reasonable to assume that the health of the user or other persons
may be endangered.
Infineon Technologies AG • Fiber Optics • Wernerwerkdamm 16 • Berlin D-13623, Germany
Infineon Technologies, Inc. • Fiber Optics • 1730 North First Street • San Jose, CA 95112, USA
Infineon Technologies K.K. • Fiber Optics • Takanawa Park Tower • 20-14, Higashi-Gotanda, 3-chome, Shinagawa-ku • Tokyo 141, Japan