V23806-A34-C2 Datasheet, PDF (4/5 Pages) Infineon Technologies AG – Single Mode FDDI 1x9 Transceiver with SC Receptacle

Pin Description
Pin Name
Level
RxV_EE Rx Ground Power
Supply
RD
Rx Output PECL
Data
Output
RDn Rx Output PECL
Data
Output
SD
Rx Signal PECL
Detect
Output
active
high
RxV_CC Rx +5 V
Power
Supply
TxV_CC Tx +5 V
Power
Supply
TDn Tx Input PECL
Data
Input
TD
Tx Input PECL
Data
Input
TxV_EE Tx Ground Power
Supply
Stud Pin Mech.
Support
Pin # Description
1
Negative power supply,
normally ground
2
Receiver output data
3
Inverted receiver
output data
4
A high level on this output
shows that optical data is
applied to the optical
input.
5
Positive power supply,
+5 V
6
Positive power supply,
+5 V
7
Inverted transmitter
input data
8
Transmitter input data
9
S1/2
Negative power supply,
normally ground
Stud connected to V_EE
Regulatory Compliance
Feature
Standard
Comments
Electrostatic
Discharge (ESD)
to the Electrical
Pins
MIL-STD 883C
Method 3015.4
Class 1 (>1000 V)
Immunity:
Electrostatic
Discharge (ESD)
to the Duplex SC
Receptacle
EN 61000-4-2
IEC 61000-4-2
Discharges of ±15kV
with an air discharge
probe on the receptacle
cause no damage.
Immunity:
Radio Frequency
Electromagnetic
Field
EN 61000-4-3
IEC 61000-4-3
With a field strength of
10 V/m rms, noise
frequency ranges from
10 MHz to 1 GHz. No
effect on transceiver
performance between
the specification limits.
Emission:
FCC Class B
Noise frequency range:
Electromagnetic EN 55022 Class B 30 MHz to 1 GHz
Interference (EMI) CISPR 22
EYE SAFETY
This laser based single mode transceiver is a Class 1 product. It
complies with IEC 60825-1 and FDA 21 CFR 1040.10 and
1040.11.
To meet laser safety requirements the transceiver shall be oper-
ated within the Absolute Maximum Ratings.
Caution
All adjustments have been made at the factory prior to ship-
ment of the devices. No maintenance or alteration to the
device is required.
Tampering with or modifying the performance of the device
will result in voided product warranty.
Note
Failure to adhere to the above restrictions could result in a modifica-
tion that is considered an act of “manufacturing,” and will require,
under law, recertification of the modified product with the U.S. Food
and Drug Administration (ref. 21 CFR 1040.10 (i)).
Laser Data
Wavelength
Total output power (as defined by IEC: 50 mm
aperture at 10 cm distance)
Total output power (as defined by FDA: 7 mm
aperture at 20 cm distance)
Beam divergence
1300 nm
2 mW
180 µW
4°
Required Labels
FDA
IEC
Complies with 21 CFR
1040.10 and 1040.11
Class 1 Laser Product
Laser Emission
Indication of laser
aperture and beam
Fiber Optics
V23806-A34-C2, Single Mode FDDI 1x9 Transceiver
4