TLE42994V33_14 Datasheet, PDF (5/33 Pages) Infineon Technologies AG – Extreme Low Current Consumption In ON State

3
Pin Configuration
3.1
Pin Assignment TLE42994GMV33 (PG-DSO-14)
TLE42994V33
Pin Configuration
RADJ
1
D2
GND 3
GND 4
GND 5
EN 6
RO
7
14
SI
13 I
12 GND
11 GND
10 GND
9
Q
8
SO
P in Co n fig _ P G-DS O-1 4 .vsd
Figure 2 Pin Configuration (top view)
3.2
Pin Definitions and Functions TLE42994GMV33 (PG-DSO-14)
Pin
Symbol
1
RADJ
2
D
3, 4, 5 GND
6
EN
7
RO
8
SO
9
Q
10, 11, 12 GND
Function
Reset Threshold Adjust
connect an external voltage divider to adjust reset threshold;
connect to GND for using internal threshold
Reset Delay Timing
connect a ceramic capacitor to GND for adjusting the reset delay time;
leave open if the reset function is not needed
Ground
connect all pins to PCB and heatsink area
Enable
high signal enables the regulator;
low signal disables the regulator;
connect to I if the Enable function is not needed
Reset Output
open collector output; internally linked to the output via a 20kΩ pull-up resistor;
leave open if the reset function is not needed
Sense Output
open collector output; internally linked to the output via a 20kΩ pull-up resistor;
leave open if the sense comparator is not needed
Output
block to GND with a capacitor close to the IC terminals, respecting the values given
for its capacitance C_Q and ESR in the table “Functional Range” on Page 10
Ground
connect all pins to PCB and heatsink area
Data Sheet
5
Rev. 1.1, 2014-07-03