TLE4963-1M_16 Datasheet, PDF (12/17 Pages) Infineon Technologies AG – High Precision Automotive Hall Effect Latch for 5V Applications

TLE4963-1M
Specification
3.3
Operating Range
The following operating conditions must not be exceeded in order to ensure correct operation of the TLE4963-
1M.
All parameters specified in the following sections refer to these operating conditions unless otherwise
mentioned.
Table 5 Operating Conditions Parameters
Parameter
Symbol
Min.
Values
Typ.
Max.
Unit Note or
Test Condition
Supply voltage
Output voltage
Junction temperature
Output current
Magnetic signal input
frequency¹⁾
V_DD
3.0
V_Q
-0.3
T_j
-40
I_Q
0
f_SW
0
5.5
V
5.5
V
170
°C
5
mA
10
kHz
1) For operation at the maximum switching frequency the magnetic input signal must be 1.4 times higher than for static
fields.This is due to the -3dB corner frequency of the internal low-pass filter in the signal path.
3.4
Electrical and Magnetic Characteristics
Product characteristics involve the spread of values guaranteed within the specified voltage and ambient
temperature range. Typical characteristics are the median of the production and correspond to V_DD = 5 V and
TA = 25°C. The below listed specification is valid in combination with the application circuit shown in Figure 7.
Table 6 General Electrical Characteristics
Parameter
Symbol
Values
Min.
Typ.
Supply current
I_S
1.1
1.5
Reverse current¹⁾
I_SR
Output saturation V_QSAT
0.2
voltage
Output leakage
current
I_QLEAK
Output fall time¹⁾
t_f
0.17
0.24
Output rise time¹⁾ t_r
0.4
0.5
Output jitter¹⁾²⁾
t_QJ
0.28
Delay time¹⁾³⁾
t_d
11.5
15
Power-on time¹⁾⁴⁾
t_PON
50
Max.
2.5
2.5
0.5
10
1
1
1
30
100
Chopper frequency¹⁾ f_OSC
350
1) Not subject to production test, verified by design/characterization.
2) Output jitter is the 1σ value of the output switching distribution.
Unit
mA
mA
V
μA
μs
μs
μs
μs
μs
kHz
Note or Test Condition
for V_DD = -0.3 V and 170°C
I_Q = 5 mA
1.2 kΩ / 50 pF, see Figure 4
1.2 kΩ / 50 pF, see Figure 4
For square wave signal with 1 kHz
see Figure 4
V_DD = 3 V, B ≤ B_RP - 0.5 mT or
B ≥ B_OP + 0.5 mT
Data Sheet
12
Revision 1.0 2016-01-12