IM811 Datasheet, PDF (5/7 Pages) ILSI America LLC – Direct pin to pin drop-in replacement for industry-standard packages

MEMS Oscillator, Ultra Performance, High Freq., LVCMOS/ HCMOS Compatible, 80.0 MHz to 220.0MHz IM811 Series
Pin Functionally
Pin Symbol
Pin Description
Functionality
OE
1
ST
Tri-state
Standby
High or Open = specified frequency output
Low = Output is high impedance, only output is disabled.
High or Open = specified frequency output.
Low = Output is low. Device goes to sleep mode. Supply current
reduces to standby current.
2
GND
Power
Electrical ground
3
Out
Output
Oscillator output
4
Vdd
Power
Power supply voltage
Notes:
1. In OE or ST mode, a pull-up resistor of 10.0 kΩ or less is recommended if Pin 1 is not externally
driven
2. A capacitor of value 0.1 µF or higher between Pin 4 (Vdd) and Pin 1 (GND) is required.
Timing Diagrams:
Pin Assignments
OE
ST
1
Top View
4 Vdd
GND 2
3 OUT
Figure 8: Startup Timing (OE/ Mode)
Figure 9: Standby Resume Timing ( Mode Only)
Figure 10: OE Enable Timing (OE Mode Only)
Figure 11: OE Disable Timing (OE Mode Only)
ILSI America Phone [phone] ● Fax [phone] ●email: [e-mail] ●
www.ilsiamerica.com
Specifications subject to change without notice
Rev: 01/30/16_A
Page 5 of 7