ICS2305 Datasheet, PDF (3/9 Pages) Integrated Circuit Systems – 3.3 VOLT ZERO DELAY, LOW SKEW BUFFER

ICS2305
3.3 VOLT ZERO DELAY LOW SKEW BUFFER
ZERO DELAY BUFFER
External Components
The ICS2305 requires a minimum number of external components for proper operation. Decoupling
capacitors of 0.01 mF should be connected between VDD and GND on pins 4 and 5, and VDD and GND
on pins 13 and 12, as close to the device as possible. A series termination resistor of 33Ω may be used to
each clock output pin to reduce reflections.
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the ICS2305. These ratings,
which are standard values for IDT commercially rated parts, are stress ratings only. Functional operation of
the device at these or any other conditions above those indicated in the operational sections of the
specifications is not implied. Exposure to absolute maximum rating conditions for extended periods can
affect product reliability. Electrical parameters are guaranteed only over the recommended operating
temperature range.
Item
Supply Voltage, VDD
All Inputs and Outputs
CLKIN and FBIN inputs
Electrostatic Discharge (HBM)
Ambient Operating Temperature (Commercial)
Ambient Operating Temperature (Industrial)
Storage Temperature
Junction Temperature
Soldering Temperature
Recommended Operation Conditions
Rating
7V
-0.5 V to VDD+0.5 V
-0.5 V to 5.5 V
2000 V
0 to +70° C
-40 to +85° C
-65 to +150° C
150° C
260° C
Parameter
Ambient Operating Temperature (Industrial)
Ambient Operating Temperature (Commercial)
Power Supply Voltage (measured in respect to GND)
Min.
-40
0
+3.0
Typ.
Max.
+85
+70
+3.6
Units
°C
°C
V
IDT™ / ICS™ 3.3 VOLT ZERO DELAY LOW SKEW BUFFER
3
ICS2305
REV E 081709