ICS85214I Datasheet, PDF (5/15 Pages) Integrated Circuit Systems – LOW SKEW, 1-TO-5 DIFFERENTIAL-TO-HSTL FANOUT BUFFER

Integrated
Circuit
Systems, Inc.
ICS85214I
LOW SKEW, 1-TO-5
DIFFERENTIAL-TO-HSTL FANOUT BUFFER
TABLE 4D. HSTL DC CHARACTERISTICS, V_DD = 3.3V±5%, V_DDO = 1.8V±0.2V, TA = 0°C TO 85°C
Symbol Parameter
Test Conditions
Minimum
Typical
Maximum
V_OH
Output High Voltage;
NOTE 1
V_OL
Output Low Voltage;
NOTE 1
1
1.4
0
0.4
V_OX
V_SWING
Output Crossover Voltage
Peak-to-Peak
Output Voltage Swing
38% x (V_OH - V_OL) + V_OL
0.6
60% x (V_OH - V_OL) + V_OL
1.1
NOTE 1: Outputs terminated with 50Ω to ground.
Units
V
V
V
V
TABLE
5.
AC
CHARACTERISTICS,
V
DD
=
3.3V±5%,
V=
DDO
1.8V±0.2V,
TA
=
0°C
TO
85°C
Symbol Parameter
Test Conditions
Minimum Typical Maximum
CLK0, nCLK0
700
f_MAX
Output Frequency
CLK1
300
t_PD
Propagation Delay; NOTE 1
IJ 700MHz
1.0
1.8
tsk(o) Output Skew; NOTE 2, 4
40
tsk(pp) Part-to-Part Skew; NOTE 3, 4
300
t_R / t_F
Output Rise/Fall Time
20% to 80%
200
800
CLK0, nCLK0
46
54
odc
Output Duty Cycle
CLK1
IJ 266MHz
44
56
All parameters measured at f_MAX unless noted otherwise.
The cycle to cycle jitter on the input will equal the jitter on the output. The part does not add jitter.
NOTE 1: Measured from the differential input crossing point to the differential output crossing point.
NOTE 2: Defined as skew between outputs at the same supply voltage and with equal load conditions.
Measured at output differential cross points.
NOTE 3: Defined as skew between outputs on different devices operating at the same supply voltages
and with equal load conditions. Using the same type of inputs on each device, the outputs are measured
at the differential cross points.
NOTE 4: This parameter is defined in accordance with JEDEC Standard 65.
Units
MHz
MHZ
ns
ps
ps
ps
%
%
85214AGI
www.icst.com/products/hiperclocks.html
5
REV. A JUNE 1, 2005