IC-TW8_13 Datasheet, PDF (20/63 Pages) IC-Haus GmbH – 16-BIT SIN/COS INTERPOLATOR WITH AUTO-CALIBRATION

iC-TW8 16-BIT SIN/COS INTERPOLATOR
Pin Configuration Mode
preliminary
Jan 9, 2013 Page PC8/15
Pin Configuration
In pin configuration mode, the iC-TW8 is config-
ured by applying different voltages to configura-
tion inputs C0, C1, C2, and C3 (pins 30, 31, 32,
and 33 respectively). Each configuration input rec-
ognizes 12 different voltage levels which together
select one of 12⁴ = 20,736 separate operational
configurations for the device.
The desired voltage levels are typically set using a
resistive voltage divider on each of the configura-
tion inputs as shown in Figure 11. Thus, only 8
resistors are required to completely configure the
iC-TW8.
Do not use
decoupling caps!
V_DD
R01
R02
V_DD
R11
R12
V_DD
R21
R22
V_DD
R31
R32
AVDD
C0
iC-TW8
C1
C2
C3
Table 1 shows the recommended resistor values for
setting the configuration levels. The resistors must
be 1% (or better) tolerance to guarantee reliable
operation under all conditions.
Configuration
Level
11
10
9
8
7
6
5
4
3
2
1
0
Divider
Ratio
0.87
0.80
0.73
0.67
0.60
0.54
0.46
0.40
0.33
0.27
0.20
0.13
Rx1
[k]
0.00
3.01
4.02
4.99
6.04
6.98
8.06
9.09
10.0
11.0
12.1
∞
Rx2
[k]
∞
12.1
11.0
10.0
9.09
8.06
6.98
6.04
4.99
4.02
3.01
0.00
Table 1: Pin Configuration Resistor Values
An open circuit is shown as infinite (∞) resistance
and a short circuit is shown as zero resistance in
Table 1.
1% resistors as close to iC-TW8
configuration pins as possible.
Figure 11: Pin Configuration Resistors
The resistors should be located as close to the con-
figuration input pins as possible and no decoupling
capacitors should be used.
Copyright © 2011–2013 iC Haus
www.ichaus.com