IC-WD Datasheet, PDF (2/12 Pages) IC-Haus GmbH – SWITCHED-MODE DUAL VOLTAGE REGULATOR

iC-WD A/B/C
SWITCHED-MODE DUAL VOLTAGE REGULATOR
Rev D1, Page 2/12
DESCRIPTION
The device iC-WD is a monolithic switching regula-
tor with two downstream 5 V resp. 3.3 V linear reg-
ulators. In view of the high efficiency of the down
converter for an input voltage range of 8 to 36 V, the
iC-WD family is well-suited for industrial applications
which require a stabilised 5 V resp. 3.3 V power sup-
ply with minimal power dissipation and few compo-
nents.
Switching transistor, free-wheeling diode and oscil-
lator are integrated, limiting the necessary external
elements for the switching regulator to the inductor,
the back-up capacitor and one resistor. This resistor
determines the regulator’s cut-off current and thus its
efficiency in the particular application at hand.
The downstream linear regulators feature a low resid-
ual ripple even with relatively small smoothing capac-
itors in the µF range. The output voltages have an
internal reference and are specified ±5% in the en-
tire operating and temperature range. The use of two
mutually independent linear regulators makes it pos-
sible to isolate the voltage supply of sensitive ana-
logue circuits or sensors from the supply for digital
and driver devices.
The chip temperature and the output voltages are
monitored. A fault is signalled via the current-limited
open-collector output NER, for example by an LED
display or a logical link with other error signals from
the system. In the event of overtemperature, the
switching regulator is disabled to reduce the power
dissipation of the chip.
PACKAGES SO8, SO8tp, DFN10 to JEDEC Standard
PIN CONFIGURATION SO8, SO8tp
(top view)
1
NER
2
VBR
3
VHL
4
GND
8
VB
7
VCCA
6
VCC
5
VH
PIN FUNCTIONS
No. Name Function
1 NER Error Output
2 VBR Pin for shunt
3 VHL Pin for inductor
4 GND Ground (reference voltage)
5 VH Intermediate Voltage
6 VCC Output (200 mA)
7 VCCA Output (25 mA)
8 VB Supply Voltage
The Thermal Pad (optional) is to be connected to a Ground Plane on the PCB.
PIN CONFIGURATION DFN10
(top view)
1
10
2
9
iC−WDx
3
8
...
4
7
...yyww
5
6
PIN FUNCTIONS
No. Name Function
1 NER Error Output
2 n.c.
3 VBR Pin for shunt
4 VHL Pin for inductor
5 GND Ground (reference voltage)
6 GND Ground (reference voltage)
7 VH Intermediate Voltage
8 VCC Output (200 mA)
9 VCCA Output (25 mA)
10 VB Supply Voltage
The Thermal Pad is to be connected to a Ground Plane on the PCB.
Orientation of the package label ( WDx ...yyww) may vary.