English
Language : 

IC-WD Datasheet, PDF (11/12 Pages) IC-Haus GmbH – SWITCHED-MODE DUAL VOLTAGE REGULATOR
iC-WD A/B/C
SWITCHED-MODE DUAL VOLTAGE REGULATOR
EVALUATION BOARD
Rev D1, Page 11/12
For the iC-WD devices an Evaluation Board is avail- the schematic as well as the layout of the Evaluation
able for test purpose. The following figures show Board.
VB
GND
CVB
4.7 µF
RNER
1.2 kΩ
RVB
1Ω
8
VB
2
VBR
LVH
220 µH
3
VHL
CVH
4.7 µF
VH
5
VH
SWITCHING REGULATOR VH
DNER
LED
NER
OSCILLATOR
1 NER
THERMAL
SHUTDOWN
LOW VOLTAGE
ERROR DETECTION
iC−WD
GND
4
REFERENCE
VREF
REG VCC
REG VCCA
VCC
6
VCC
CVCC
4.7 µF
GND
VCCA
7
VCCA
CVCCA
1µF
GND
Figure 8: Schematic diagram of the Evaluation Board
Figure 9: Evaluation Board (components side)
This specification is for a newly developed product. iC-Haus therefore reserves the right to change or update, without notice, any information contained herein,
design and specification; and to discontinue or limit production or distribution of any product versions. Please contact iC-Haus to ascertain the current data.
Copying – even as an excerpt – is only permitted with iC-Haus approval in writing and precise reference to source.
iC-Haus does not warrant the accuracy, completeness or timeliness of the specification on this site and does not assume liability for any errors or omissions
in the materials. The data specified is intended solely for the purpose of product description. No representations or warranties, either express or implied, of
merchantability, fitness for a particular purpose or of any other nature are made hereunder with respect to information/specification or the products to which
information refers and no guarantee with respect to compliance to the intended use is given. In particular, this also applies to the stated possible applications or
areas of applications of the product.
iC-Haus conveys no patent, copyright, mask work right or other trade mark right to this product. iC-Haus assumes no liability for any patent and/or other trade
mark rights of a third party resulting from processing or handling of the product and/or any other use of the product.