IC-LO_16 Datasheet, PDF (10/25 Pages) IC-Haus GmbH – TRIANGULATION SENSOR

iC-LO
TRIANGULATION SENSOR
CONFIGURATION PARAMETERS
preliminary
Rev B3, Page 10/25
Thresholds
TIM:
Transimpedance (page 13)
THSW:
Warning Threshold weak received light
(page 15)
THSE:
Error Threshold weak received light
(page 15)
HYSD:
Comparator hysteresis difference
(page 14)
HYSS:
Comparator hysteresis sum (page 14)
DISHYS:
Disable Comparator hysteresis
(page 14)
Parameter set OBF (object far)
SPF:
Diode segmentation (page 14)
POTF:
Digital potentiometer (page 14)
Parameter set OBN = (objekt near)
SPN:
Diode segmentation (page 14)
POTN:
Digital potentiometer (page 14)
LED Driver
LCO:
LCC:
PW:
PER:
LED driver mode (page 23)
LED pulse current (S. 23)
Pulse width (page 12)
Pulse frequency (page 12)
Digital Filter
FIN:
Number of averaged measurements
(page 15)
FIM:
Number of complementary
measurements (page 15)
SKO:
Sample point in time (page 16)
Internernal Oscillator
OSC:
Frequency trimming (page 17)
Output Configuration
SOCNO: Output mode (page 16)
SOEN:
Output enable (page 16)
TAR:
Turn-on delay (page 16)
TAF:
Minimum on-time (page 17)
Opcode/Status Register
OP:
Operating modes (page 18)
SOI:
Last output (page 18)
WARNI:
Last output status / warning (page 18)
TII:
Last transimpedance value (page 18)
NKDF:
Last comparator result (page 18)
KSW:
Last warning threshold result (page 18)
KSE:
Last error threshold result (page 18)
LEDOK: LED status (page 18)
Device Designator
REV:
Revision (page 21)