HPMX-2005 Datasheet, PDF (2/12 Pages) Agilent(Hewlett-Packard) – Silicon Bipolar RFIC 100 MHz Vector Modulator

HPMX-2005 Absolute Maximum Ratings, T_A = 25°C
Symbol Parameter
Absolute
Units Maximum^[1]
P_diss
Power Dissipation ^[2,3]
mW
500
LO_in
V_CC
∆V_Imod,
∆V_Qmod
LO Input Power
Supply Voltage
Swing of V_Imod about V_Iref or
V_Qmod about V_Qref
dBm
V
V_p-p
15
10^[4]
5^[4]
V_Iref, V_Qref
T_STG
T_j
Reference Input Levels
Storage Temperature
Junction Temperature
V
5
°C
-65 to 150
°C
150
Thermal Resistance^[2]:
θ_jc = 125°C/W
Notes:
1. Operation of this device above any one
of these parameters may cause
permanent damage.
2. T_C = 25°C (T_C is defined to be the
temperature at the ends of pin 3 where
it contacts the circuit board).
3. Derate at 8 mW/°C for T_C > 87°C.
4. This voltage must not exceed V_CC by
more than 0.8 V.
HPMX-2005 Guaranteed Electrical Specifications, T_A = 25°C, Z_O = 50 Ω
V_CC = 5 V, LO = -12 dBm @ 100 MHz (Unbalanced Input), V_Iref = V_Qref = 2.5 V (unless otherwise noted).
Symbol Parameters and Test Conditions
Units Min. Typ.
I_d
P_out
LO_leak
ε_mod
Device Current
Output Power
V_Imod = V_Qmod = 3.25 V
P_out - LO at Output
V_Imod = V_Qmod = 2.5 V
Average
Modulation
Error
√(V_Imod
-
2.5)²
+
(V -
Qmod
2.5)²
= 0.75
V
mA
dBm
dBc
%
14
-7
-5
30
36
2.5
Max.
17
5
HPMX-2005 Summary Characterization Information. T_A = 25°C, Z_O = 50 Ω
V_CC = 5 V, LO = -12 dBm @ 100 MHz (Unbalanced Input), V_Iref = V_Qref = 2.5 V (unless otherwise noted).
Symbol Parameters and Test Conditions
Units
R_in
R_in-gnd
VSWR_LO
VSWR_O
-
Input Resistance (I_mod to I_ref or Q_mod to Q_ref)
Input Resistance to Ground (Any I, Q Input to Ground)
LO VSWR (50 Ω)
25 - 200 MHz Bandwidth
Output VSWR (50 Ω)
25 - 200 MHz Bandwidth
Output Noise Floor
V_Imod = V_Qmod = 3.25 V
Ω
Ω
dBm/Hz
IM₃
DSB Third Order Intermodulation Products
A_i
RMS Amplitude Error
P_i
RMS Phase Error
dBc
dB
degrees
Typ.
10 k
10 k
1.5:1
2.5:1
-134
33
0.15
1.0
7-55