English
Language : 

BS87B12A-3 Datasheet, PDF (185/224 Pages) Holtek Semiconductor Inc – Touch A/D Flash MCU with OCVP
BS87B12A-3/BS87C16A-3/BS87D20A-3
Touch A/D Flash MCU with OCVP
Interrupt Operation
When the conditions for an interrupt event occur, such as a Touch Key Counter overflow, a TM
Comparator P or Comparator A match or A/D conversion completion, etc, the relevant interrupt
request flag will be set. Whether the request flag actually generates a program jump to the relevant
interrupt vector is determined by the condition of the interrupt enable bit. If the enable bit is set high
then the program will jump to its relevant vector; if the enable bit is zero then although the interrupt
request flag is set an actual interrupt will not be generated and the program will not jump to the
relevant interrupt vector. The global interrupt enable bit, if cleared to zero, will disable all interrupts.
When an interrupt is generated, the Program Counter, which stores the address of the next instruction
to be executed, will be transferred onto the stack. The Program Counter will then be loaded with a
new address which will be the value of the corresponding interrupt vector. The microcontroller will
then fetch its next instruction from this interrupt vector. The instruction at this vector will usually
be a JMP which will jump to another section of program which is known as the interrupt service
routine. Here is located the code to control the appropriate interrupt. The interrupt service routine
must be terminated with a RETI, which retrieves the original Program Counter address from the
stack and allows the microcontroller to continue with normal execution at the point where the
interrupt occurred.
The various interrupt enable bits, together with their associated request flags, are shown in the
accompanying diagrams with their order of priority. Some interrupt sources have their own
individual vector while others share the same multi-function interrupt vector. Once an interrupt
subroutine is serviced, all other interrupts will be blocked, as the global interrupt enable bit, EMI
bit will be cleared automatically. This will prevent any further interrupt nesting from occurring.
However, if other interrupt requests occur during this interval, although the interrupt will not be
immediately serviced, the request flag will still be recorded.
If an interrupt requires immediate servicing while the program is already in another interrupt service
routine, the EMI bit should be set after entering the routine to allow interrupt nesting. If the stack
is full, the interrupt request will not be acknowledged, even if the related interrupt is enabled, until
the Stack Pointer is decremented. If immediate service is desired, the stack must be prevented from
becoming full. In case of simultaneous requests, the accompanying diagram shows the priority that
is applied. All of the interrupt request flags when set will wake-up the device if it is in SLEEP or
IDLE Mode, however to prevent a wake-up from occurring the corresponding flag should be set
before the device is in SLEEP or IDLE Mode.
Rev. 1.20
185
December 05, 2016