BC68F2123 Datasheet, PDF (18/117 Pages) Holtek Semiconductor Inc – Sub-1GHz OOK/FSK TX Soc 1K Flash MCU

BC68F2123
Sub-1GHz OOK/FSK TX Soc 1K Flash MCU
Last page or
present page
PC9~PC8
PC High Byte
TBLP Register
Program Memory
Data
14 bits
TBLH Register
Data High Byte
User Selected
Register
Data Low Byte
Table Program Example
The following example shows how the table pointer and table data is defined and retrieved from the
microcontroller. This example uses raw table data located in the Program Memory which is stored
there using the ORG statement. The value at this ORG statement is "300H" which refers to the start
address of the last page within the 1K words Program Memory of the device. The table pointer is
setup here to have an initial value of "06H". This will ensure that the first data read from the data table
will be at the Program Memory address "306H" or 6 locations after the start of the last page. Note that
the value for the table pointer is referenced to the first address of the last page if the "TABRDL [m]"
instruction is being used. The high byte of the table data which in this case is equal to zero will be
transferred to the TBLH register automatically when the "TABRDL [m]" instruction is executed.
Because the TBLH register is a read-only register and cannot be restored, care should be taken
to ensure its protection if both the main routine and Interrupt Service Routine use table read
instructions. If using the table read instructions, the Interrupt Service Routines may change the
value of the TBLH and subsequently cause errors if used again by the main routine. As a rule it is
recommended that simultaneous use of the table read instructions should be avoided. However, in
situations where simultaneous use cannot be avoided, the interrupts should be disabled prior to the
execution of any main routine table-read instructions. Note that all table related instructions require
two instruction cycles to complete their operation.
Table Read Program Example
tempreg1 db ? ; temporary register #1
tempreg2 db ? ; temporary register #2
:
:
mov a,06h ; initialise low table pointer - note that this address is referenced
mov tblp,a ; to the last page or present page
:
:
tabrdl tempreg1 ; transfers value in table referenced by table pointer data at program
; memory address "306H" transferred to tempreg1 and TBLH
dec tblp ; reduce value of table pointer by one
tabrdl tempreg2 ; transfers value in table referenced by table pointer data at program
; memory address "305H" transferred to tempreg2 and TBLH in this
; example the data "1AH" is transferred to tempreg1 and data "0FH" to
; register tempreg2
:
:
org 300h ; sets initial address of program memory
dc 00Ah, 00Bh, 00Ch, 00Dh, 00Eh, 00Fh, 01Ah, 01Bh
:
:
Rev. 1.00
18
January 11, 2017